SMART-AVI SaviGateway G300 User Manual - page 6
6
NETWORK CONTROL
1. Enter the G300 IP address into a web browser. Note: Microsoft internet explorer and Edge are not
supported. We recommend Chrome.
2. When the webpage opens it will have completed a scan of your network and should display your en-
coders and decoders. The Encoders are listed up and down in a column on the left side. The decoders
are listed left to right near the top.
3. For convenience if you place your mouse cursor over the name of an encoder or decoder and left click
a window for that device will open. Under the General tab there is a field titled “Board Name:” You can
name the device here with something helpful in identifying the location or video stream like “Lobby” or
“Front dining area”. See Figure 6-1.
4. You connect decoders to encoders by clicking on the box at the intersection between them in the ma-
trix. In the example shown in Figure 6-2 The stream on the encoder named E300-1 is being sent to
decoders D300-1 and D300-2. The stream on encoder E300-2 is being sent to D300-3. The stream
on E300-3 is being sent to D300-4 and D300-5.
5. Click on the name of each decoder and click the “START PLAYING” button to display the video. There
will be a short delay before this takes effect. If the red button says “STOP PLAYING the video is already
streaming.
Figure 6-1
Figure 6-2