Sds-1002/3 point to point wall plate extenders setup guide for more information visit our website, or talk to one of our technical team tel: +44 (0) 1306 628264 www.Smart-e.Co.Uk sds-1002 & 1003 setup guide copyright 2012 smart-e ltd page 1.
Step 1 – connecting the sds-rx1000 front panel 1. First connect the video signals to the display device – rgbhv, hdmi and composite video (cv). 2. Next the audio, the 2 x audio outputs are the same signal from the wall plate transmitter however, there will be separate inputs for the rgbhv and compos...
Step 2 – connecting the sds-rx1000 rear panel 1. Connect 3 x cat stp type cables (cat 5-8) to the rj45s, it is important to use screened twisted pair(stp) cable to maintain signal integrity and guarantee the full 30m specification. It is not necessary to know the numbering of the cables as the wall ...
Sds-1002/3 setup guide – stp cable/rs232 step 3 – connecting the cat 5-8 stp cable it is important to connect the cat cables to the correct rj45s and in the correct sequence. Firstly turn the plate over so the pcb is on show. If the cables are not numbered then follow this sequence: 1. Connect each ...
Cv rgbhv audio hdmi audio step 5 – adding the network cable for the sds-1002 on the sds-tx1002 there is an additional rj45 connector on the wall plate. This is for a direct ethernet connection which requires a fourth cat cable. The connection is a back to back rj45 coupler allowing ethernet signals ...
The ‘select’ button toggles around the inputs selecting both the ddc and audio signals respectively. The status leds indicate the selected input together with which audio in being transmitted. Step 6 – input selection the sds-1002/3 extends three different video types to the display. Although all th...
