Smart+ Products SPP1500SBH Owner's Manual - page 6
PREPARATION
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Only operate this heater
in upright position with feet attached.
When using remote control, please pull out the clear insulating film to activate the battery as shown below.
MAINTENANCE
1. Unplug the unit and let it cool completely.
2. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary.
After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater.
3. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause
damage or deteriorate the surface of the heater.
4. DO NOT immerse the heater in water.
5. Wait until the unit is completely dry before use.
6. Clean the air filter after 3 months of use or when the filter appears to be dirty. The below diagram shows the location of the
air filter. Remove the Air Intake Grille by pulling handle down and outwards. Wash the filter with clean water. Allow filter to
completely dry before reassembling back onto the heater