Smart+ Products SPP15AIM User Manual - page 6
5
DANGER
1. Remove the exterior and interior packaging. Check that the ice basket and ice scoop are
included. If any parts are missing, please contact customer service.
2. Clean the interior with lukewarm water and a soft cloth. Also, remove and clean ice basket.
3. Find a location for your ice maker that is protected from direct sunlight and other sources of
heat (ex. stove, furnace, radiator). Place the ice maker on a level surface. Maker sure that
there is at least 4 inches of space between the back and sides of your ice maker and the
wall.
4. Allow one hour for the refrigerant fluid to settle before plugging ice maker in.
5. The appliance must be positioned so that the plug is accessible.
* Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged please call our customer service.
1. This unit should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to
minimize the possibility of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not under
any circumstances, cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician.
3. This appliance requires a standard 110-120volt, 60Hz electrical outlet with three-prong
ground.
Before using your ice maker, it is strongly recommended that you clean it thoroughly.
1. Take out the ice basket.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. Then use the water to rinse the inside parts, and drain out the water by unplugging the
drain cap on the side.
4. The outside of the ice maker should be cleaned regularly with a mild detergent solution and
warm water.
5. Dry the interior and exterior with a soft cloth.
6. When the machine has not been used for a long period of time, open water drain cap to
drain water completely from water reservoir.
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER
CONNECTING YOUR ICE MAKER
!
CLEANING AND MAINTAINING YOUR ICE MAKER