X-port ™ 20 switch (xp20-2000i) installation guide for a 2000i with an nec mt860 or nec mt1060 projector 99-00486-00 rev b0
Fcc warning this equipment has been tested and found to comply with the limits for a class a digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This ...
Contents installing the x-port 20 switch in a 2000i-dv/dvx..........................1 to install the x-port 20 switch .................................................................. 1 to connect a guest laptop....................................................................... 7 contacting sma...
99-00486-00 rev b0
Installing the x-port 20 in a 2000i with an nec mt860 or mt1060 projector these instructions show you how to: • install an x-port 20 switch in a 2000i that’s equipped with an nec 860 or 1060 projector • connect a guest laptop the x-port 20 unit is an rs-232 serial switch for connecting a laptop to t...
3. Remove the sticker covering the lower db9 opening. Place the supplied label over this opening. Db9 connector opening (sticker removed) supplied label 2000i (back leg removed for clarity) compu ter 2 4. While propping up the electronics tray with one hand (so it doesn’t fall suddenly), remove the ...
5. Carefully swing the electronics tray down so it hangs vertically. Open electronics tray 6. Install the x-port 20 switch on the studs in the electronics tray. Using a phillips no. 1 screwdriver, secure it in place with the supplied screws and washers. X-port 20 switch stud (x 4) installing the x-p...
7. Unplug the db9 cable from the serial controller and plug it into the gender changer on the x- port 20 switch. Unplug db9 cable from here serial controller plug db9 cable into gender changer x-port 20 switch 8. Attach the loose end of the db9 female-female ribbon cable to the serial controller usi...
9. If you don’t have a room control module installed, attach the supplied mod6 cable to the audio amplifier and the x-port 20 switch. Then go to step 12. Supplied mod6 cable audio amplifier 10. If you have a room control module installed, disconnect the mod6 cable (that runs between the audio amplif...
11. Connect the supplied mod6 cable to the audio amplifier and the x-port 20 switch. Supplied mod6 cable 12. Swing the electronics tray back to its original position, and insert the two button head screws that you removed earlier. Avoid pinching any cables. 13. Connect the supplied three-cable lapto...
To connect a guest laptop 1. Extend the laptop end of the umbilical from the rear of the 2000i until it reaches the laptop/videoconferencing shelf. 2. Connect the three cables that comprise the laptop end of the umbilical − the computer 2 audio, computer 2 video and computer 2 serial − to the approp...
X-port 20 switch installation guide for the 2000i 99-00486-00 rev b0 8 customer support smart’s technical support team welcomes your call. However, you may want to contact your local reseller first if you experience problems with any smart product. Smart’s resellers can readily provide you with quic...
