SmartDisk PhotoBank User Manual - Back Side Panel Area

4 

Back Side Panel Area 

The back side panel area contains the memory card slot for your Compact 

Flash (CF) and Microdrive (MD) memory cards. 

Charging the Battery 

PhotoBank uses a built-in lithium ion rechargeable battery to provide 

power to the product when used remotely. When the battery is depleted it 

will normally take up to 3 hours to recharge fully. Your new battery may 

be only partially charged, so before using the unit with battery power you 

must first charge the battery. Note that regardless of the state of the 

battery, you can always operate the unit while the AC adapter is attached. 

To charge the battery, plug the included AC adapter into a wall outlet, 

and then plug the adapter’s DC plug into the DC input jack on the unit. 

When the power adapter is connected, the battery charge LED will be red 

while charging and will be green when fully charged. 

About the Hard Disk 

The PhotoBank internal hard drive comes pre-formatted from the factory 

in FAT32 format.