1/3” color ccd camera smartec stc-3002 user’s manual.
1. Lead (pb) free rohs compliance 2. Performance: 540 tv lines of resolution. 3. Digital signal processor: sony hq1 4. Long life and high reliability are achieved by the use of a ccd image device. This makes the camera 100 percent solid state. No longer is an image tube needed. 5. The minimum illumi...
And cooling device included, should be used. 4. Clean the front face to the pick-up device it is recommended that the pick-up device surface be cleaned before lens installation or whenever the lens is changed. Cleaning should be done using a chamois, a very fine soft cloth, lens tissue or cotton tip...
Tv system pal ntsc digital signal processor sony hq1 image sensor 1/3” sony high super had ccd number of total pixels 795(h)×596(v) 811(h)×508(v) synchronizing system internal / line lock (ac version only) resolution 540tvl minimum illumination 0.08lux @ f1.0 color mode automatically switches to b/w...
Electronic shutter speed control aes on: 1/50 (60) sec.~1/100,000 sec. Aes off: 1/50 (60) sec. Lens mount cs mount adjustment vr l.L v-phase; dc level power supply 12vdc /24vac ; 90~260vac power consumption 12vdc /24vac: 3.5w ; 90~260vac: 4.5w lead free yes operation temperature -10~50 operation hum...
N auto iris lens connector (4-pin type) the lens connector supplies the auto-iris lens (not supplied) with dc power and a video signal or dc control signal. O control switch sw1. Blc: backlight compensation off / blc switch sw2. Day/night mode: d/n / color switch sw3. S.Agc/agc: super or automatic g...
The power supply of 90~260vac. Sw1. Blc (back light compensation) mode switch: when the object is dark by strong light (sun illumination etc.), turn on blc switch to make object becomes bright. Sw2. D/n mode switch: color / d/n switch. D/n: color mode automatically switches to b/w mode under 2 lux. ...
Sw3. S.Agc/agc: s.Agc: when camera has been installed in the environment with low illumination, the sensitivity of the camera rises (26db). Agc: 26db. (color mode only.) in order to activate d/n function (color mode automatically switches to b/w mode under 2 lux), please switch to s.Agc. Sw4. Sync m...
