Smartech 1:10 SCALE 4WD OFF-ROAD BUGGY Instruction Manual

Summary of 1:10 SCALE 4WD OFF-ROAD BUGGY

  • Page 1

    Instruction manual technical data length...................................420mm width.....................................245mm height....................................180mm wheel base...........................268mm tread (f/r).....................240/245mm wheel diameter...............108*53mm ...

  • Page 2

    15%-30% fuel notice before assembly the following tools are needed for assembly. You must buy them from the local hobby shops apart from the kits we provided. Please read and comprehend this instruction manual before assembly. Tools needed for assembly hexagonal wrenches scissor hobby knife cross sl...

  • Page 3

    Trouble shooting problems reasons solutions engine does not start engine flameout just after starting bad reaction and response from engine car is hard to contorl 1. No fuel in tank or in carburetor. 2. The spark plug is damaged, or the port fire has not been charged. 3. The fuel pipe, air filter or...

  • Page 4

    1. Adjust carburetor please read the instructions carefully before staring engine. Before staring carburetor is been adjusted in standard and not required readsjust readjust according to user’s requirement main needle calibrating screw 1-1.5mm opening (rich) opening (rich) closing (lean) closing (le...

  • Page 5

    Low/middle rpm is adjusted with trimming needle. For the first drive, try to run as set. Stop driving, and the neutral tends to stop… finally to stoppage, adjust trimming needle to continue. Pay attention to balancing for adjusting both main and trimming needles note: when needles are changed, be su...

  • Page 6

    3. Adding fuel use the special fuel for the model. After filling, please fasten the cover of the fuel tank. 4. Chock button send the fuel into the inlet of carburetor by pushing chock button. Push the button twice more until fuel reaches the gate. The inlet of the carburetor 5. Starting engine heat ...

  • Page 7

    6. Over choked engine cylinder is flooded with fuel, plug is wet and recoil starter is heavy, remove plug/pull recoil starter for 20-30 times to discharge the fuel. 7. Stopping engine placing neutral position, remove air cleaner and turn off air intake opening . Or block exhaust opening. Note: use g...

  • Page 8

    Bearing φ10*φ5*4 e-clip φ2.5 philips head screw tpf3*30 ×4 ×2 ×2 103080 103082 103080 (e2.5) grease 103080 103080 103079 103104 (tt3*15) 103105 (tt3*15) 103105 103104 103104 (tpf3*30) 103105 (tpf3*30) 103081 103083 103083 103083 (m4*3) 103083 (m4*3) 103081 103041 103041 103041 103041 103081 103100 (...

  • Page 9

    Rear gear case centre decrease mount centre decrease mount assembly 08 103024(60mm) 103025(68mm) 103031 103075 103075 103101 103101 103053 103086 103086(m3*3) 103036 103086 103052 103054 103085 103102 103103 103083 103083 (m4*3) 103084(m4*4) 103088 (tpf3*32) 103088(tpf3*32) 103073 103073 103073 (m3*...

  • Page 10

    24mm front susp. Arm mount (l&r) rear susp. Arm mount (l&r) front&rear susp. Arm mount (l&r) 6 7 8 09 103028 103028 m3*12 103068 (m3*12) 14mm 103068 (m3*12) 103068 (m3*12) 103037 103037 103037 103037 103011 103011 103010 103010 103070 103070 (tpf3*10) 103010 (tpf3*10) 103070 103069 103069 103069 (tt...

  • Page 11

    F&r shock absorber unit front shock absorber assembly rear shock absorber assembly 9 10 11 ② 10 rear shock absorber 2pcs front shock absorber 2pcs 0-1mm bubble 18mm to remove air bubbles, move the positon upper and down slowly. E-clip φ2.5 ×8 o ring p3 ×8 ball end head 5.8 ×4 103033 103033 (e2.5) 10...

  • Page 12

    Servo saver system assembly fuel tank assembly 12 13 11 103030 103072 103072 (tm3*10) 103089 103089 103106 103106 103106 103106 80cc 103106 103106 (tpf3*10) 103106 (tt3*6) 103106 (p4) 103106 (p3) 103030 103022 103022 (tm3*16) 103022 (tm3*16) 103022 (m3) 103022 (m3) 103030 103030 (e5.0) 103030 (iso3*...

  • Page 13

    Upper floor upper floor assembly 14 15 12 10mm tt3*10 x8 iso2*10 ×2 iso3*12 ×2 tpf3*6 ×2 tpf3*10 ×2 tt3*15 x2 103019 103110 103055 103055 (tt3*10) 103110 301030 103110 (tpf3*10) 103026 301010 (m2*10) 301010 103027 (tpf3*10) 103027 (tpf3*10) 103027 (tpf3*10) 103027 103019 (tpf3*6) 103019 (tpf3*10) 10...

  • Page 14

    Engine part engine assembly 16 17 ② 13 103064 103064 103065 103063 103062 (m3) 103062 103063 103107 103062 (iso3*8) 103062 (iso3*8) 103047 (m3*10) 403063 (iso3*10) 103066 103051 103045 103046 103049 103046 103046(e7.0) 103075 103048 103047 isoo3*30 x2 x1 x2 x1 x1 x6 spring washer m3 nylon nut x2 m3 ...

  • Page 15

    19 14 103057(m4) 103057 103056 103056 ( m4) m4 nylon nut x4 front and rear tires assembly throttle rod & brake rod 18 103043 (pb2*10) 103043 103044 iso2*10 x1 isoh3*3 ×3 washer 3.2*8*0.5.

  • Page 16

    103114 103114 103114 (e2.3) 103114(p3) 103114(p3) 103114 103114 103114 103114 103114 103114 front shock absorber 2pcs 103113 103113 (e2.3) 103113(p3) 103113(p3) 103113 103113 103113 103113 103113 103113 car body 20 ② 15 f&r shock absorber unit 9 rear shock absorber 2pcs 0-1mm bubble 18mm to remove a...

  • Page 17

    Universal drive shaft bearing 22 15 ② 16 front tire rear tire 18cxp engine aluminum exhaust pipe 24 401770 103075 ( φ10*φ5*4) 103120 103120 ( m4*4) 115010 115012 182120 103076 ( φ10*φ15*4) apply super glue between wheel rim and tire, when dry, repeat the procedure on the other side of the wheel unti...

  • Page 18

    103430/103450 part list (1) 103011-rear constuction wall 103012-rear bumper 103013-front bumper 103015-rear brace mount (l&r) 103122-wing mount 103016-washer 103017-tie rod 103018-chassis 103019-upper floor 103020-rear shock tower 103021-front shock tower 103022-steering plate 103023-transmission sh...

  • Page 19

    103430/103450 part list (2) 103033-front shock absorber 103034-rear shock absorber 103035-susp. Arm axle 103037-lower susp. Shaft (l&r) 103038-front linker axle 103039-wheel shaft 103043-throttle pulling rod 103044-brake rod 103036-brake lever 103041-rolling bearing 103042-rolling bearing 103048-clu...

  • Page 20

    103430/103450 part list (3) 103055-anttena x4 pcs 103056-rear wheel unit 103057-front wheel unit iso3*8 x4 tpf3*10 x6 washer x2 isoo3*30 x2 st2.9*12 x4 tt3*12 x2 m3 nylon nut x4 m3 nylon nut x1 m3 nylon nut x2 iso3*10 x1 103058-front rim 103059-rear rim 103060-rear tire 103061-front tire 103062-engi...

  • Page 21

    103430/103450 part list (4) 103079-steering gear (female) 103080-diff.Gear(l) 103081-driving gear (accessory) 103082-diff. Gear (s) 103083-universal outdrive b 103084-universal outdrive c 103085-diff.Gear shaft 103087-brake caliper 103088-cross bar 103089-tie rod 103090-tie rod 103110-servo mount 10...

  • Page 22

    103430/103450 part list (5) 103112-rear gear box unit 401770-drive shaft 103120-muffler(mental) 103113-front shock absorber (mental) 103114-rear shock absorber (mental) 103115-3kg servo tt3*15 x2 tt3*15 x2 103116-diff. Gear shaft 103117-diff. Speed gear (single) 103119-clutch gear / bearing 152120-1...

  • Page 23

    Explosive diagram 103122 103016 103014 103015 103020 103016 103014 103017 103034 103020 103029 103035 103035 103037 103041 103071 103108 103056 103108 103041 103039 103023 103010 103037 103011 103029 103023 103037 103010 103035 103035 103010 103037 103020 103039 103041 103108 103071 103056 083071 10...