User manual longo programmable controller lpc-2.Ca1 special module version 2 smarteh d.O.O. / trg tigrovcev 1 / 5220 tolmin / slovenia / tel.: +386(0)5 388 44 00 / e-mail: info@smarteh.Si / www.Smarteh.Si.
Longo programmable controller lpc-2.Ca1 special module written by smarteh d.O.O. Copyright © 2012, smarteh d.O.O. User manual document version: 002 july 1, 2012 i.
Longo programmable controller lpc-2.Ca1 special module standards and provisions: standards, recommendations, regulations and provisions of the country in which the devices will operate, must be considered while planning and setting up electrical devices. Work on 230 vac network is allowed for author...
Longo programmable controller lpc-2.Ca1 special module longo programmable controller lpc-2.Ca1 special module 1 description...................................................................................1 2 features.....................................................................................
Longo programmable controller lpc-2.Ca1 special module 1 description lpc-2.Ca1 rfid reader is intended to be used as an identity verification device at room entrance. Module also provides display for four different messages and requests, usually activated from other module inside the room. This mess...
Longo programmable controller lpc-2.Ca1 special module 2 features figure 1: lpc-2.Ca1 special module table 1: technical data rfid reader leds for showing activated messages & requests: occupied, do not disturb, room service, sos ok “ √ ” led fault “ x ” led power led internal fault led internal buil...
Longo programmable controller lpc-2.Ca1 special module 3 operation operation of the ca1 module is also dependent on parameters received on rs485 communication channel. Reader rfid field is active always when module is powered up. If tag is put inside rfid field, reader tries to resolve rfid tag code...
Longo programmable controller lpc-2.Ca1 special module 4 installation 4.1 connection scheme figure 2: connection scheme 4.
Longo programmable controller lpc-2.Ca1 special module table 2: k1 k1.1 gnd ground k1.2 10 – 24 vdc power supply input k1.3 rs485 a data receive/send line a k1.4 rs485 b data receive/send line b table 3: leds & buttons led1: blue do not disturb on: request active off: no request led2: blue room serv...
Longo programmable controller lpc-2.Ca1 special module 4.2 mounting frame selection frame, suitable for ca1 module insertion, should be modular one at least 3 gang wide. Be careful to have corresponding flush-mounting box provided on the place where module will be positioned. Smarteh has verified fo...
Longo programmable controller lpc-2.Ca1 special module 4.3 mounting instructions figure 4: housing dimensions • dimensions in millimeters. All connections, module attachments and assembling must be done while module is not connected to the main power supply. Module should not be mounted outdoors. Se...
Longo programmable controller lpc-2.Ca1 special module 1. Set the correct rs485 address (s1 switch) for lpc-2.Ca1 (refer to the table 4). 2. Connect interconnection cable to the connector k1. Max. Allowed tractive force is 30 n. 3. Put the lpc-2.Ca1 in mounting frames 4. Cover lpc-2.Ca1 with cover p...
Longo programmable controller lpc-2.Ca1 special module 4.4 module labeling table 5: labels label 1: label 2: label description: • lpc-2.Ca1 is the full product name • p/n: 225ca110v01001is the part number • 225 – general code for lpc-2 product family, • ca1 – short product name, • 10 – year of code ...
Longo programmable controller lpc-2.Ca1 special module 5 technical specifications table 6: technical specifications power supply from mcu interconnection connector type rj12 6/6 power consumption 2w rfid type em4100, 125khz, manchester 64, read only max. Reading distance 4 cm dimensions (w x h x d) ...
Longo programmable controller lpc-2.Ca1 special module 6 changes the following table describes all the changes to the document. Date v. Description 1.7.2012 002 cgp general update. 1.1.2010 001 the initial version, issued as lpc-2.Ca1 module usermanual. 11.
Longo programmable controller lpc-2.Ca1 special module 7 notes 12.
