Smartenit Harmony P2 Quick Start Manual - page 2
2014 Compacta International, Ltd. - Rev.
9/14
Harmony P2, iSmartenit, and Smartenit are trademarks of Compacta Intl. Ltd.
INSTEON is a registered trademark of SmartLabs, Inc. X10 is a registered trademark of X10.
iSmartenit Application Interface Basics
Adding devices
Step 1
Step 2
Step 3
Step 4
Adding a Wizard
Step 1
Step 2
Step 3
Wizards are macros that can
be set to automatically control
devices on your network based
on time or the state of other
devices.
Click on the Wizards button to
get to the Wizards menu.
Once in the Wizards menu, click
the “+” icon to add a new Wizard.
The next screen will allow you
give the Wizard a name and add
conditions and effects.
Click on the “+” icon under the “When”
section to add a condition for when the
Wizard will trigger a desired action.
The “When” can be set up to trigger
based on time of day, day of week, status
of another device, or all of the above.
Click the disk icon to save when finished.
Step 4
Click on the “+” icon under the “Do
this” section to add an effect that
will be triggered when the “When”
condition is met.
Select a device and the action to
take place when the condition is
met.
Click the disk icon to save when
finished.
(949) 429-3303
Technical Support
Smartenit.com
NOTE: Visit
http://wiki.smartenit.com/index.php?title=ISmartenit
for more info.
Click on the Default Area icon to
open devices menu for this area.
Other Areas can be added here by
clicking the “+” icon. Areas can
be used to organize devices into
sub-categories.
To discover devices (ZigBee and
INSTEON*), click on the “+” icon
and select “Discover devices”.
You’ll be notified that you have
250 seconds to add your devices
and be prompted to confirm.
*INSTEON and X10 devices
require connection to an
INSTEON/X10 interface, such as
our ZBPLM.
As your devices add to the
gateway, they will populate in
the area device list and have the
most commonly used functionality
available for each device. (Ex.
On/Off toggle button for load
controllers)
Alternatively, you may add devices
manually. This is required for X10 and
WiFi devices, but INSTEON devices can
be added manually as well.
Give your device a name and pick an
icon by clicking on the pencil icon.
Then choose the device you want to
add from the wheel selector and enter
the appropriate information for device
enrollment.
Click the save
icon when finished.