1. DL manuals
  2. Smartgen
  3. Controller
  4. HGM6100K Series
  5. Operating Manual

Smartgen HGM6100K Series Operating Manual

Manual is about: Automatic Generator Module

Summary of HGM6100K Series

  • Page 1

    Hgm6100k series automatic generator module operating manual smartgen electronics.

  • Page 2

    Smartgen electronic equipment co., ltd no.28 jinsuo road zhengzhou henan province p. R. China tel: 0086-371-67988888/67981888 0086-371-67991553/67992951/67992952 0086-371-67981000(overseas) fax: (0086)-371-67992952/67981000 web: http://www.Smartgen.Com.Cn http://www.Smartgen.Cn email: sales@smartgen...

  • Page 3: Content

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 3 of 31 content 1 summary ..................................................................................... 4 2 performance and characteristics ............................... ...

  • Page 4

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 4 of 31 1 summary hgm6100k series genset controller integrating digital, intelligent and network techniques is used for automatic control system of diesel generator. It can carry o...

  • Page 5

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 5 of 31 load power current ia, ib, ic active power kw inactive power kvar apparent power kva power factor cos accumulate total gens power kwh ■ mains have over voltage, under volta...

  • Page 6

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 6 of 31 connection terminals, flush type installation, compact structure, easy installation. 3 specification operating voltage dc8.0v to 35.0v, continuous power consumption ≤2w) ac...

  • Page 7

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 7 of 31 4 operation 4.1 key function stop/ reset can stop generator under mode of manual/auto; can reset alarming under stop; to test panel indicators are ok or not, pressing this ...

  • Page 8

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 8 of 31 e) when preheat relay is over, oil relay is outputting 1s and then start relay-output; if genset fails in starting during “cranking time”, the oil and start relays stop out...

  • Page 9

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 9 of 31 4.3 manual operation 1) hgm6120kc, auto starts mode is active when press and its indicator is illuminating. Press , then controller under “manual test mode” and its indicat...

  • Page 10

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 10 of 31 no. Type description 2 gens over current when controller detected the current of genset is over than threshold and over current delay set as 0, controller will send warnin...

  • Page 11

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 11 of 31 no. Type description alarm set for alarming, it will send a stop alarm signal and it will be displayed in lcd 6 speed signal lost alarm when controller detected genset spe...

  • Page 12

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 12 of 31 description of terminal blocks connection pin function dim description 1 dc plant supply input (-ve) 2.5mm system dc negative input. (battery negative). 2 dc plant supply ...

  • Page 13

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 13 of 31 pin function dim description input 15 magnetic pickup +ve connect to magnetic pickup device. 16 magnetic pickup -ve 17 temp. Sensor input connecting water/cylinder tempera...

  • Page 14

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 14 of 31 7 parameter range and define all parameters of hgm6100k series are as following: 7.1 parameters table (table 1) num parameter range default description 1 mains volt normal...

  • Page 15

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 15 of 31 num parameter range default description 8 number of crank (1-10)times 3 when engine start no success, most of cranking numbers. When reach setting crank numbers, controlle...

  • Page 16

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 16 of 31 num parameter range default description 25 over speed (0-6000)rpm 1710 when the engine speed is over than the point and hold great than 2 seconds, generator over speed is ...

  • Page 17

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 17 of 31 num parameter range default description 31 lose speed delay (0-20.0)s 5.0 when speed is zero and remain for the delay, send out shutdown alarm. When the delay is zero, sen...

  • Page 18

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 18 of 31 num parameter range default description 40 fuel pump off threshold (0-100)% 80 when the fuel level higher than the set value and for 10 seconds, the output fuel pump off s...

  • Page 19

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 19 of 31 num parameter range default description 65 freq disconnect (10-30)hz 14 when generator frequency is over than this point, starter will disconnect. 66 op disconnect (0-400)...

  • Page 20

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 20 of 31 num content description 2 ets solenoid hold the designated programmable output relay will energize when a stop signal has been activated. The output will remain energized ...

  • Page 21

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 21 of 31 num content description 14 reserved 15 reserved 16 reserved 17 reserved 7.3 programmable digit input 1-5 table (all is valid when connect grand (b-) (table 3) num content ...

  • Page 22

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 22 of 31 num content description active and a remote start signal/mains failure occurs the hgm6110/20k will not give a start command to the generator. If this input signal is then ...

  • Page 23

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 23 of 31 num content description 5 reserved 2 7.5 conditions of crank succeed (table 5) num content 0 magnetic pickup sensor 1 generator 2 magnetic pickup sensor + generator 3 magn...

  • Page 24

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 24 of 31 8 parameter setting after controller powered on, press to enter into the parameters setting menu: 1 set parameters. 2 information. 3 set languages. ■ set parameters when e...

  • Page 25

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 25 of 31 ■ set language user may set display interface language as chinese, english, spanish and russian. Note: press the key will exit setting interface at any time. 9 sensor sele...

  • Page 26

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 26 of 31 common units' conversion table 1n/m 2 (pa) 1kgf/cm 2 1bar (1b/in 2 ) psi 1pa 1 1.02×10 -5 1×10 -5 1.45×10 -4 1kgf/cm 2 9.8×10 4 1 0.98 14.2 1bar 1×10 5 1.02 1 14.5 1psi 6....

  • Page 27

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 27 of 31 the operation situation of engine and the voltage and frequency of the ac generator. If there is abnormal, stop the generator, then check connections of each part accordin...

  • Page 28

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 28 of 31 hgm6120kc typical wiring diagram single phase 2 wires (hgm6120kc) 2-phase 3 wires (hgm6120kc) note: recommend that the output of crank and fuel expand high capacity relay..

  • Page 29

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 29 of 31 12 installation the controller is designed to panel installation mode, and it is fixed by clamps when it is installed. The overall dimension and panel tapping dimension ar...

  • Page 30

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 30 of 31 other equipment. 4) alternating current input hgm6100k series controller to external input current transformer, electric current transformer side must be 5a, while the cur...

  • Page 31

    Hgm6100k series automatic generator module hgm6100k series automatic generator module issue 2011-04-12 version 1.6 page 31 of 31 symptom possible remedy crank no success check wiring of fuel solenoid. Check starting batteries. Check speed sensor and its connections. Refer to engine manual. Crank fai...