Smartguard AEC-931A2BSD-SP4 User Manual - (See Fig. 5 & Fig. 6):
5
Installation to a junction box using crossbar mount
(see fig. 5 & fig. 6):
1. Attach the crossbar (part no.
⑦
) to junction box and fix by screw C.
2. Feed the cable through the back mounting plate.
3. Fix the mounting plate to crossbar (part no.
⑦
) by screw D
4. Connect the black wire (live wire) from the AC power cord to the
single black wire coming from Smartguard using one of the supplied
wire nuts (part no.
⑧
).
5. Connect the white wire from the AC power cord to the white wire
coming from Smartguard using one of the supplied wire nuts (part no.
⑧
).
6. Connect the green/yellow wire from the AC power cord to the
green/yellow wire coming from Smartguard
TM
using one of the
supplied wire nuts (part no.
⑧
).
7. Make sure the polarity is correct.
8. Attach the unit to the mounting plate. You will first need to angle the
unit back so that the catch at the top of the mounting plate fits into slot
on the back of the unit. Next lower the unit until holes at the bottom of
the mounting plate and unit are flush. Then screw (screw A) into this
hole, tightening carefully.
Fig. 5
Screw D
Screw A
Screw C