Smarthome 1623PC PC-IR Linc User Manual - page 3
Parts included with PC-IR Linc
• The PC-IR Linc controller box
• AC Adapter (12-Volts DC, 300mA)
• Double headed Stick-on IR Emitter
• CD-ROM Software
• Serial Cable
Quick Start Instructions
Learning
an IR
Command
1. Click on the "Learn" button.
2. Enter a file name for the command.
3. The red "Active" indicator will begin to blink rapidly.
4. Point the remote control at the PC-IR Linc.
5. Press and hold the button on the remote control until the red
"Active" indicator turns off.
6. The IR Linc status bar will turn blue if the command was success-
fully learned or red if the command was not learned.
(See page 8 for more detailed instructions)
Overview
• During playback, the Active indicator
is used to show that IR signals are
being transmitted. During program-
ming, it will indicate that the unit is
ready to learn an IR signal.
• The two IR/Learn blast emitters
emit IR light to control the AV
devices. During programming, they
sense the IR light from the teaching
remote.
• The Probe indicator is used to indi-
cate when a Smarthome probe
is detecting an ON condition.
• The three IR Out jacks for optional
external IR emitters.
• The Probe jack will accept the
Smarthome Probes to monitor the
power status of equipment.
• The Powerlinc/RS232 Cable jack
connects the serial cable between
the PC-IR Linc and a computer.
• The 12VDC, 300mA is for the power
12-volt adapter included in the kit.
Using a
built-in IR
command
1. Click and select an entry on the "Select Device Type" menu.
2. Click and select an entry on the "Select Brand" menu.
3. Choose a number from the "Select Code" menu.
4. Choose the IR function to be sent.
5. Click the "Send" button to have the IR Linc transmit the command.
(See page 7 for more detailed instructions)
3
1623PC_WEB_MAN_021005.qxd 2/14/2005 9:23 AM Page 3