Smarthome 2383W User Manual

Summary of 2383W

  • Page 1

    Switchlinc 2-way tm remote control switch and transmitter for models: #2383w switchlinc 2-way 5-amp (white) #2383i switchlinc 2-way 5-amp (ivory) about switchlinc’s certification switchlinc has been thoroughly tested by its etl semko, a nationally recognized independent third-party testing laborator...

  • Page 2

    Congratulations ! You’ve just purchased the highest quality powerline-controllable wall switch available. Switchlinc 2-way switch is the world’s first two-way powerline remote control switch. It gives you remote control of lighting and inductive loads. It is also a transmitter, so it can be used to ...

  • Page 3

    Caution!! Read and understand these instructions before installing. • this device is intended for installation in accordance with the national electric code and local regulations in the united states, or the canadian electrical code and local regulations in canada. • for indoor use only. • connect o...

  • Page 4

    Preparation before installing switchlinc, please familiarize yourself with the following and take the necessary precautions listed here: • be sure that the fuse has been removed or the circuit breaker is turned off to the circuit being controlled. Installing switchlinc with the power on will expose ...

  • Page 5

    2. Remove the trim plate from the existing switches. 3. Unscrew and pull the existing switches from the wall box. 4. Disconnect the wires from the existing switches. 5. If the switchlinc is being installed into a 3/4/5-way circuit, the switchlinc multi-way companion switch must be installed in the w...

  • Page 6

    Setting the primary address each switchlinc requires a primary address to operate. It ships from the factory with “a1” as the default address; it will also have this address after performing a factory reset. Any of the 256 plc/x10 addresses can be programmed. The switchlinc does not use code wheels ...

  • Page 7

    The scenes for all these modules can be setup simultaneously using the same programming sequence. Signals sent by transmit-enabled smarthome products, like those on the preceding page, will be received and understood by the switchlinc switch! Scenes can be programmed with a maxi-controller or any tr...

  • Page 8

    Other features disable plc transmissions the switchlinc’s ability to transmit may be disabled if the feature is not needed, interferes with other home automation tasks, or just to cut down on the amount of plc signals on the lines. It can be re-enabled later if necessary. Please note that the electr...