Lamplinc tm intelligent lamp modules packed with features for models: #2000sls lamplinc plus #2000sls3 lamplinc plus with ground pin #2000shl lamplinc plc #2000shl3 lamplinc plc with ground pin lamplink plus& plc for web (mar04).Qxd 3/15/2004 9:58 am page 1.
Congratulations congratulations on purchasing lamplinc, the most powerful lamp module available. Lamplinc is based on our popular switchlinc tm wall switches and has many of the same features. Lamp modules are the easiest way to add sophisticated lighting control to your home. No tools or electrical...
Caution! Read and understand these instructions before installing. This device is intended for installation in accordance with the national electric code and local regulations in the united states, or the canadian electrical code and local regulations in canada. To reduce the risk of overheating and...
Setting the primary address each lamplinc requires a primary plc address to operate. It ships from the factory with “a1” as the default address; it will also have this address after performing a fac- tory reset. Any of the 256 plc addresses can be programmed. The lamplinc does not use flimsy code wh...
Setting the default on-level the default on-level is the brightness level that lamplinc will adjust the light when the switched on locally or by a powerline carrier (plc) on-command. Each time the lamplinc is turned on, the light will come to the same level. This is ideal for situa- tions where the ...
Remotely setting the default on-level (optional) this is the alternative method of adjusting the lamplinc’s default on-level. 1. Transmit the “clear” sequence: 2. Send the house/unit code for the lamp module and adjust the dim level or send preset dim level. 3. Send the following command to lock-in ...
Removing a module from a scene: 1. Transmit the “clear” sequence: 2. Using a controller, send the module’s primary address plus an on or off. 3. Send the following command sequence: 4. Transmit the scene address (house and unit code) that is to be removed. The lamp’s light will blink indicating that...
Factory reset (to default settings) the factory reset procedure can be used to clear the lamplinc’s memory and restore its factory default settings. This procedure will clear the unit of all scene addresses and fade-on/off rates. 1. Unplug the lamplinc from the receptacle for about 10 seconds. 2. Wh...
Understanding the local control feature local control allows a user to turn on a lamp without having to send a signal to the lamplinc module. A lamp can be turned on and off manually by the switch on the lamp and the lamplinc will respond to this. There are three possibilities: the load control feat...
If these solutions have been tried, the manual has been reviewed, and you still cannot resolve an issue you're having with the lamplinc, please call our technical support dept. At 949-221-9200 or e-mail tech@smarthome.Com . 10 possible cause lamplinc was triggered by a scene or legitimate plc signal...
How powerline signals travel around a home and how to improve reliability most homes in north america have two lines of 120 volts coming into the home from the utility company. This split-single phase electricity is divided out at the home’s breaker box into the circuits that feed light switches, pl...
Plug-in incandescent, fluorescent, inductive lighting devices 400 watts 1 base (primary) address of 256 possible up to 64 scene addresses (plus only) (primary address) 1 of 31 possible (3.2%-100%) or resume dim (scene address) 1 of 32 possible (0%-100%) (plus only) 0.125 to 9 seconds if programmed l...
