Smarthome x10 relay wall switch owners manual (#x10ws13a, x10ws13ai) page 1 of 7 x10ws13a rev: 10/7/2011 6:08 pm.
About x10 wall switch ............................................................................................................................... 3 features & benefits ...................................................................................................................................
About x10 wall switch this elegant and full-featured switch gives you local control and x10 capabilities for the connected light or other non-dimmable load. Remotely turn the light on and off from an x10 controller or send commands to other x10 devices when you use x10 wall switch’s paddle. Switch p...
Getting started cautions and warnings read and understand these instructions before installing and retain them for future reference. This product is intended for installation in accordance with the national electric code and local regulations in the united states or the canadian electrical code and ...
Installation 1) turn off the circuit breaker (or remove fuses) supplying power to the switch location 2) remove the existing wallplate from the switch you are replacing. Then, unscrew the switch and remove it from the junction box. 3) disconnect the wires from the switch you are replacing. If the wi...
Setting the x10 address 1) press & hold x10 wall switch’s set button until x10 wall switch beeps x10 wall switch’s led will begin blinking 2) using an x10 controller, send the x10 address you want to assign followed by the on command three times. For example, to assign the address a1, send “a1 on a1...
Page 7 of 7 x10ws13a rev: 10/7/2011 6:08 pm troubleshooting problem possible cause solution make sure the circuit breaker is turned on. Make sure the air gap (set button) is not pulled out. X10 wall switch is not controlling the load. X10 wall switch may not be getting power. Check the junction box ...
