Smartlink IntelPage 5W Installation Manual - page 7
Intelpage 5W (POCSAG) Transmitter Installation Manual v1.3
6
Connecting Intelpage to a Paging Terminal
The unit can be connected to almost any paging system worldwide. DIP switches on the rear panel of the
unit customize the way the Intelpage operates.
If you are connecting the Intelpage to a SmartWatch XP Monitoring Software, the DIP Switch
configuration is as follows.
The DIP switches on the Intelpage come preconfigured as above. If you are connecting the unit to a third
party encoder, consult its documentation for the transmitter settings required.
5.
SmartWatch XP Monitoring Software Setup
If you are connecting the Intelpage unit to a SmartWatch XP Monitoring Software, you must use an
“RS232” type connector set and the supplied straight through RJ45-RJ45 cable (blue CAT-5E).
Once the Intelpage are connected to the Dongle (RS232 DB25 Female to the Male end of the Dongle), the
SmartWatch XP Monitoring software must be setup to match and ensure correct operation.
1.
Ensure you are logged on as Maintenance User (see SmartWatch XP Help for details).
2.
From the SmartWatch XP Main Screen, click Interfaces and then select Ports as shown below.