Smartlink MEDI-MINDER User Manual

Summary of MEDI-MINDER

  • Page 1

    Medi-minder user manual.

  • Page 2

    T a b l e o f c o n t e n t s table of contents..................................................................1 introduction............................................................................. 1 medi-minder features..........................................................2 pendants & de...

  • Page 3

    2 m e d i - m i n d e r f e a t u r e s i/p 1, 2 & o/p 1, 2, 3 plug pack 9v dc 300ma (part no. 840-050) hardwird inputs & outputs lead assy 230mm 6 way (part no. 450-191) common - black input 1 - red input - white output 1 - green output 2 - brown output 3 - blue rechargeable battery 4.8v ni-mh 1600...

  • Page 4: Normal Operation

    3 p e n d a n t s & d e t e c t o r s wrist/neck chain or fixed waterproof 2 way pendants (106-183) (915.8 to 927.2 mhz) twr wall mounted wireless call point (100-841) wireless interface for psa 240vac smoke detector (100-842) psa 240vac smoke detector with 9v rechargeable battery (100-054) neck cha...

  • Page 5: To Call For Help

    4 to call for help you can make your medi-minder call for help by either: 1 pressing the help (red) button on the medi- minder unit. 2 the help (red) button will flash rapidly and the medi- minder unit will start beeping. This is a pre-alarm warning, while this is sounding you can cancel the help al...

  • Page 6

    5 d i s p l a y s a n d w a r n i n g s mains on light flashing ac power fail – check/make sure that the mains power plug pack is plugged in and turned on at the power point. Flashing & battery low light flashing - check/make sure that the battery switch is turned on underneath the medi- minder unit...

  • Page 7

    6 c e l l u l a r s i g n a l q u a l i t y note: medi-minder 3g version only to check the signal quality/strength: while the medi-minder 3g unit is in normal/operation mode, press the cancel green button and the signal strength displays/flashes for 2 seconds. To the medi-minder 3g unit displays/fla...

  • Page 8: © Copyright Smartlink

    7 s p e c i f i c a t i o n s warning: for safety reasons, only connect equipment with a telecommunications compliance label. This includes customer equipment previously labelled permitted or certified. © copyright smartlink “a division of ness corporation pty ltd” november 2015 smartlink medi-minde...