Smartplanet CDM-1 Instruction Manual - Operating Instructions
7
OPERATING INSTRUCTIONS
Place Corn Dog Maker on
a flat, dry surface.
1. Brush vegetable oil or cooking spray on cooking sur-
faces.
2. Keep the unit closed while preheating. The Green Ready
Light will illuminate when the unit is ready for use.
3. Insert wooden skewer in each hot dog (this is optional).
4. Spoon batter evenly, about 1/2 to 2/3 full, in corn dog
cavity on the cooking plate.
5. Place the cut hot dogs into the batter and then add a
little more batter. Remember that the batter will rise and
enclose the hot dog so there is no need to overfill.
6 Close the corn dog maker by lowering the upper plate
onto the lower plate.
7. Bake until corn dogs are lightly brown (shorter or longer
depending on personal preference). Do not open the Corn
Dog Maker during the first 2 minutes of cooking.
8. Once the corn dogs are cooked carefully remove them
using a wooden spoon or plastic spatula. Do not use a
sharp or metal object, as it could damage the non-stick
surface. Use caution as the heating surfaces as well as the
sides and top of the appliance may be hot.
9. If you wish to bake more corn dogs, re-brush cooking
surface with oil and preheat appliance.
10. After use, disconnect the plug from the power outlet.
Allow the corn dog maker to cool down before cleaning.