Smartplanet SmartSolar Installation Instructions Manual - Sliding Gate Opener Set Up
10
SmartSolar™
Installation Instructions & Owners’ Manual
Sliding Gate Opener Set Up
ESV-24 EasySlider
®
& ESV-24MS EasySlider
®
09
Fig
PLEASE NOTE: CB-11 fi rmware must be v0.65 or
higher for SmartSolar™ compatibility
WARNING: Do not connect the batteries until
Step B5 is completed.
Step B4 - Mount the Charger Board
Unplug the drive unit from mains power.
Remove the main cover, then remove the
transformer, EMC board (if fi tted) and mains power
cable.
Mount the Charger Board inside the cover using
four (4) M4x8 screws (Fig. 09).
Plug the Charger Board’s three wire harness (red/
yellow/black) into the CB-11 board’s “SBY-3”
connector (Fig. 10).
Plug the Charger Board’s one wire harness (white)
into the “24vac in” connector on CB-19 control
board (Fig. 10).
IMPORTANT WARNING: Do not connect battery
or solar panel polarity incorrectly - this will result
in serious damage to components.
Step B5 - Connect the Solar Panel
Feed the Solar Panel’s cable through black grommet
which the mains power cord ran through
Connect the red wire to the Charger Board’s
“SOLAR+” connector, and the black wire to the
“–SOLAR” connector (Fig. 11).
WARNING: During Step B6 the opener will
become active.
Step B6 - Mount & Connect the Battery
Mount the Battery Box close to the opener.
Feed the 2-core 18awg gauge cable (supplied)
through the Battery Box’s grommet.
Connect the red wire to the Battery Box’s “+”
terminal, and the black wire to the “–” terminal
(Fig. 12).
Feed the other end of the battery cable through the
drive unit’s black grommet.
Connect the red wire to the Charger Board’s
“BAT+” connector, and the black wire to the “–
BAT” connector (Fig. 11).
Step B7 - Re-setup and Test the Opener
Select Menu 7 on the control board, press “SET”,
select Sub Menu 7 (“Battery/Solar”) and enable
using the “OPEN” and CLOSE” buttons.
Setup travel limits and transmitters as per the slider
instruction manual.
Press either “OPEN” or “CLOSE” buttons, or use a
transmitter to operate the gate.
Refi t the Control Box’s cover.
1.
2.
3.
4.
5.
1.
2.
1.
2.
3.
4.
5.
1.
2.
3.
4.
10
Fig
11
Fig
Re
d Wi
re
Black
Wi
re
12
Fig
B
la
ck
F
ro
m
R
e
d
F
ro
m
To
control
Board