SmartPool Robo Kleen Plus User Manual

Other manuals for Robo Kleen Plus: User Manual

Summary of Robo Kleen Plus

  • Page 1

    Plus table of contents important safeguards 2 introduction 3 installation 4 operation 5 cleaning pattern adjustment 5 automatic shutoff and removal 6 maintenance 7 warranty 8 www.Smartpool.Com *please note: the transformer may display the name “pool hog”. This is a universal transformer that is used...

  • Page 2: Warning:

    ! Warning: to reduce the risk of fire, electrical shock, injury, or damage to your product or to bathers: ! Do not use if unit is damaged in any way. ! Use this product only for its intended use as described in this manual. ! Unit must be submerged in water to operate properly. ! When not in use, st...

  • Page 3

    Congratulations on your purchase! You will find robo- kleen plus to be the most effective pool cleaner available. Unlike water-powered cleaners, which put all dirt and debris through your existing pool pump and filter, robo-kleen plus has its own pump and filter system. This saves you money in elect...

  • Page 4: Installation

    The power supply should be positioned so that robo-kleen plus can reach all the walls of the swimming pool and must be at a minimum distance of 10 feet from the edge of the pool. Caution: insure the 110v main line outlet is protected by a ground fault circuit interrupter (gfci) or earth leakage circ...

  • Page 5: Operation

    Do not enter the swimming pool while robo-kleen plus is in operation to avoid entanglement with cord operation a. Connect the cable to the power supply b. Grasp the cleaner by a side handle and place robo-kleen plus in the pool. C. Rock the unit from front to back and side to side, releasing trapped...

  • Page 6

    Automatic shutdown and removal robo-kleen plus will automatically shut down after a work cycle of approximately 3 hours. Should a second cleaning cycle be required, switch off the power supply for at least 30 seconds before restarting. Always switch off the power supply before removing robo-kleen pl...

  • Page 7: Maintenance

    Maintenance there are only a few simple steps to maintaining your robo-kleen plus. A. Place robo-kleen plus upside down. Push the locking tabs to the side to unlock the bottom lid. Remove the bottom lid. B. Pull one of the 4 red tabs out and remove the filter bag from the bottom lid. Turn the filter...

  • Page 8

    3-year l i m i t e d w a r r a n t y this product has been manufactured, tested and inspected by smartpool, inc. In accordance with carefully specified engineering requirements. It is warranted to be free from defects in materials and workmanship under normal use and service, subject to qualificatio...