SmartRG SR300NE User Manual

Manual is about: 4 Ports, 802.11n, ADSL

Summary of SR300NE

  • Page 1

    4 ports + 802.11n wireless adsl modem user manual v 1.1.

  • Page 2

    Dsl gateway/router — user manual page 2 total 21 pages contents 1.Overview ....................................................................................................................................................... 3 1.1 about adsl ...........................................................

  • Page 3: 1.Overview

    Dsl gateway/router — user manual page 3 total 21 pages 1.Overview 1.1 about adsl an adsl modem is a broadband internet access device, which utilizes the high frequency segment of the phone line to transmit high-speed data without affecting the voice transmission. The frequency of the adsl signal is ...

  • Page 4: 2 Specification

    Dsl gateway/router — user manual page 4 total 21 pages 2 specification 2.1 interface introduction 2.1.1 indicator and interface table 2.1 item name state introduction indicator power a steady green light means the power connection works properly dsl green, shows dsl line status. Internet green, flas...

  • Page 5: 2.2 Hardware Connection

    Dsl gateway/router — user manual page 5 total 21 pages line connected with telephone line adsl connect with the line port of the adsl modem using telephone line provided. Phone connect with telephone 2.2 hardware connection introduction: 1、 use a telephone cord to connect the line port of the splitt...

  • Page 6: 3. Configuration

    Dsl gateway/router — user manual page 6 total 21 pages 3. Configuration 3.1 default configuration adsl modem has pre-configured with the vci/vpi which is in common use. 3.2 computer configuration the default ip address for adsl modem is: 192.168.1.1; the subnet mask is:255.255.255.0. Users can confi...

  • Page 7: 3.4 Wan Configuration

    Dsl gateway/router — user manual page 7 total 21 pages when you save the settings, the web page will be refreshed slowly, please wait it finished. Some settings only take effect after rebooting the router. 3.4 wan configuration if the configuration is bridge encapsulation, there is no need to config...

  • Page 8

    Dsl gateway/router — user manual page 8 total 21 pages figure 3.3 after your save, there will be one layer2 interface(atm3) added as following: figure 3.4 next, add one layer3 interface via “wan service” configuration page, and click “add” button as following: figure 3.5 you need to select one layer...

  • Page 9

    Dsl gateway/router — user manual page 9 total 21 pages figure 3.6 press “next” to enter into “wan setup - summary”, click “apply/save” to save configuration, if you need to modify the parameter, click “back” as figure 3.7. Figure 3.7 3.4.3 pppoe on atm configuration pppoe is also known as rfc 2516. ...

  • Page 10

    Dsl gateway/router — user manual page 10 total 21 pages press “next” entering the configuring interface, as figure3.9. Figure 3.9  ppp username: your account from isp to access internet.  ppp password: input the password assigned by your isp.  pppoe service name: server name of network isp. No ne...

  • Page 11

    Dsl gateway/router — user manual page 11 total 21 pages figure 3.10 press “next” to setup default dns server as following: figure 3.11 press “next” to enter into “wan setup - summary”, click “apply/save” to save configuration, if you need to modify the parameter, click “back” as figure 3.12.

  • Page 12

    Dsl gateway/router — user manual page 12 total 21 pages figure 3.12 3.4.4 ipoe on atm configuration in figure3.6, select mac encapsulation routing (mer), figure 3.13 press “next”, and the ip address can be queried from your isp, the result as figure3.14..

  • Page 13

    Dsl gateway/router — user manual page 13 total 21 pages figure 3.14 press “next” to configure services of translation on this connection, as figure 3.15: figure 3.15 press “next” to select default gateway from routing interfaces as figure 3.16: figure 3.16 press “next” to setup default dns server as...

  • Page 14: 3.5 Wireless Configuration

    Dsl gateway/router — user manual page 14 total 21 pages figure 3.17 press “next” to enter into “wan setup - summary”, click “apply/save” to save configuration, if you need to modify the parameter, click “back” as as figure 3.18 figure 3.18 3.5 wireless configuration press “wireless” on the top of we...

  • Page 15

    Dsl gateway/router — user manual page 15 total 21 pages figure 3.19 3.5.1 wireless basic setup click “basic” on the left menu to setup basic wireless parameters. In default, check “enable Wireless” box to launch wireless ap. Ssid (service set identifier): the mobile users cannot access wlan until se...

  • Page 16

    Dsl gateway/router — user manual page 16 total 21 pages figure 3.20 802.1x authentication select “802.1x” to enter 802.1x authentication page. The 802.1x authentication needs a radius server in lan. In this page, you can input radius server ip address, port number and secret key. Figure 3.21 3.5.3 w...

  • Page 17: 4 Other Configuration

    Dsl gateway/router — user manual page 17 total 21 pages figure 3.22 notice: you only can select one of allow mode or deny mode. 3.5.4 wireless advanced setup press “advanced” on the left menu to construct wireless security as figure 3.23 figure 3.23 4 other configuration 4.1 lan configuration 4.1.1 ...

  • Page 18

    Dsl gateway/router — user manual page 18 total 21 pages configuration column to change the password. Attention: please remember the password after change, otherwise you will not be able to change configuration after saving setting as figure 4.1 figure 4.1 4.1.2 configuration of modem’s ip address as...

  • Page 19: 5. Troubleshooting

    Dsl gateway/router — user manual page 19 total 21 pages • click“enable dhcp server”; • define the “start ip address” and the “end ip address” of dhcp server (for example, from 10.10.10.11 to 10.10.10.254). • input the value of lease time (measured by the second, 0 indicates permanently valid). As fi...

  • Page 20

    Dsl gateway/router — user manual page 20 total 21 pages 3、 try to run command “ping 192.168.1.1” on command line mode. If the response returns “time out”, please check ethernet connection and ip settings; 4、 if this modem is reachable, try to run ping with a known outer ip, e.G. The dns server ip of...

  • Page 21

    Dsl gateway/router — user manual page 21 total 21 pages annex:shipping list adsl modem ×1 splitter ×1 user manual ×1 power supply ×1 cable cat5 rj45 ×1 telephone line ×2 warranty certificate ×1.