Smartswitch STS-220 Manual

Manual is about: Deluxe Programmable Toilet Controller for all electric marine toilets

Summary of STS-220

  • Page 1

    1 smartswitch toilet controller model: sts-220 the unique deluxe programmable toilet controller by smartswitch was designed for all electric marine toilets with remote, fresh or salt water flushing supply via an inlet pump or water solenoid valve. The stylish control panel provides fully automatic p...

  • Page 2: Programming

    2 programming this product has three model modes of operations: model mode 1 = standard mode model mode 2 = tecma silence (series) model mode 3 = tecma prestige (series) this product has been factory default set to model mode 2 (see page 3) factory default: t1 = 20 seconds model mode = tecma silence...

  • Page 3

    3 setting t3 water valve/inlet pump time: after placing the unit in program mode, as in step 1 above, press the fill button the number of times required for the water valve/inlet pump time (one press = 0 sec’s, two = 1 second, three = 2 sec’s, etc). The tank led will flash once indicating a valid ke...

  • Page 4

    4 model timing chart this device has three different timing sequences, any one may be selected. (factory default is model mode 2 = tecma silence) mode 1: standard model mode 1 model mode 2: tecma silence (series) - factory default tecma single button emulation mode: model mode 3: tecma prestige (ser...

  • Page 5

    5 programming the device for model mode or disable features place the unit in model mode / disable features program mode: hold the fill & empty buttons down together for 3 seconds. The holding tank full led will give three flashes indicating you have entered program mode. While still holding down th...

  • Page 6: Operating Instructions:

    6 operating instructions: flush: pressing the flush button will run the auto cycle (see page 3 for details). Fill: while this button is held down the water valve/inlet pump will activate (maximum 20 seconds per press). After activation this button will be disabled. The empty button will need to be p...

  • Page 7

    7 electrical specifications: supply voltage = 12-30 volts dc (auto-sensing) quiescent current = .015 amps input = emi protected max motor output = 44 amps max valve output = 44 amps max est output = 12 amps protection = reverse polarity, over voltage, over temperature, short circuit. Connections fig...

  • Page 8

    8 fitting face panel: drill a small hole, approx 8mm, through the wall for the cable. Align panel, ensuring level and fasten with screws supplied. Remove the protective film from the clip on surround panel and clean with a soft cloth. Clip in place. Toilet control toilet control 72mm 115mm 84mm 13mm...

  • Page 9

    9 all technologies, design and intellectual property is owned by smart switch technologies ltd po box 272, waikanae. Nz phone 0064-4-293-4201 fax 0064-4-293-4201 email: info@smartswitch.Co.Nz web: www.Smartswitch.Co.Nz.