SmartThings ADT Keychain Remote Setup Manual - page 4
Troubleshooting
3
To reset the ADT Keychain Remote to factory settings:
Press and hold all four buttons for 5 seconds. The
red LED will blink fast.
Once the reset is complete, the green LED will turn
on for 5 seconds.
Release the button. If the button is released before
the reset is complete, the reset will not be successful.
Follow the Setup instructions above to setup your ADT
Keychain Remote.
If you’re still having trouble connecting the ADT Keychain
Remote please visit SmartThings.com/Support-ADT for
assistance.
1.
2.
3.
4.
4
Replacing Batteries
Coin
Keychain Remote
Remove the cover by by inserting a coin into the end
of the remote and twisting.
1.
Remove the old battery and insert a new CR2450
battery. Be sure to install the battery correctly.
Replace the cover.
2.
3.