Smartwares DIC-222 Series Instruction Manual - page 3
INSTALLATION
When installing the outdoor unit, make sure that the location you wish to install it is dry. It is important
that the camera or the electronics do not get wet.
INSTALLATION
1.
Mark the installation location
2.
Drill a hole in the wall, insert wall plugs and
screw unit onto wall.
3.
Open the panel by the arrow direction
4.
Pull the wires from the hole
1. Drill holes in the wall, insert the wall plugs in the holes. Place
the bracket and tighten the screws.
2. Connect the wires (see WIRING).
3. Mount the outdoor unit on the bracket. Make sure it is
properly secured.
4. Use the special security screw on the bottom of the unit, to
prevent theft.
5. It is possible to change the camera angle. Remove the unit
from the bracket. Loosen the screw at the back of the device
(right behind the camera), change the angle and tighten the
screw again.