1. DL manuals
  2. SMC Networks
  3. Accessories
  4. PSE550
  5. Operation Manual

SMC Networks PSE550 Operation Manual

Manual is about: Pressure Sensor

Summary of PSE550

  • Page 1

    No.Ps※※-omg0009-c product name pressure sensor model / series / product number pse550

  • Page 2: Table Of Contents

    -1- no.Ps※※-omg0009-c table of contents safety instructions 2 model identification and how to order 8 definition and terminology 8 mounting and installation 9 piping 9 wiring 9 troubleshooting 11 specification 12 specifications 12 dimensions 14.

  • Page 3: Safety Instructions

    -2- no.Ps※※-omg0009-c safety instructions these safety instructions are intended to prevent hazardous situations and/or equipment damage. These instructions indicate the level of potential hazard with the labels of "caution", "warning" or "danger". They are all important notes for safety and must be...

  • Page 4: Safety Instructions

    -3- no.Ps※※-omg0009-c safety instructions caution 1.The product is provided for use in manufacturing industries. The product herein described is basically provided for peaceful use in manufacturing industries. If considering using the product in other industries, consult smc beforehand and exchange ...

  • Page 5: Operator

    -4- no.Ps※※-omg0009-c operator this operation manual is intended for those who have knowledge of machinery using pneumatic equipment, and have sufficient knowledge of assembly, operation and maintenance of such equipment. Only those persons are allowed to perform assembly, operation and maintenance....

  • Page 6

    -5- no.Ps※※-omg0009-c ■ note ○follow the instructions given below when designing, selecting and handling the product. ● the instructions on design and selection (installation, wiring, environment, adjustment, operation, maintenance, etc.) described below must also be followed. Product specifications...

  • Page 7

    -6- no.Ps※※-omg0009-c wiring do not pull the lead wires. In particular, never lift a pressure sensor equipped with fitting and piping by holding the lead wires. Avoid repeatedly bending or stretching the lead wire, or placing heavy load on them. Repetitive bending stress or tensile stress can cause ...

  • Page 8

    -7- no.Ps※※-omg0009-c adjustment and operation do not short-circuit the load. If using the product to detect very small pressure rates, warm up the product for 20 to 30 minutes first. There will be a drift on the analogue output of approximate 1% immediately after the power supply is turned on, with...

  • Page 9

    -8- no.Ps※※-omg0009-c model indication and how to order ○option description part number remarks bracket zs-30-a with m3x5 l (2 pcs.) connector for pressure sensor controller zs-28-c 1 pc. ■ definition and terminology terms meaning f f.S. (full span/full scale) abbreviation for full span and full sca...

  • Page 10: Mounting And Installation

    -9- no.Ps※※-omg0009-c mounting and installation ■ piping ○piping connections cut the air tube perpendicularly. Grasp the air tube and insert it to resin firmly by 8 mm or more from the end the resin piping. The pulling force necessary for the piping inserted by 8 mm or more is approximate 25n. Inser...

  • Page 11

    -10- no.Ps※※-omg0009-c ○ connector and applicable pressure sensor connecting/disconnecting when connecting the connector, insert it straight onto the pin holding the lever and connector body between fingers and lock the connector by pushing the lever claw into the square groove in the housing until ...

  • Page 12: Troubleshooting

    -11- no.Ps※※-omg0009-c troubleshooting ○ cross-reference for troubleshooting problem possible cause investigation method countermeasure analogue output is not provided. (specified accuracy is not satisfied.) incorrect wiring check if the analogue output line is connected with a load. Correct the wir...

  • Page 13: Specification

    -12- no.Ps※※-omg0009-c specification ■ specifications model no. Pse550 pse550-28 rated differential pressure range 0 to 2 kpa operating pressure range -50 to 50 kpa extension analogue output range -0.2 to 0 kpa - withstand pressure 65 kpa applicable air, inert gases and incombustible gases power sup...

  • Page 14

    -13- no.Ps※※-omg0009-c ○ analogue output pse550 pse550-28.

  • Page 15

    -14- no.Ps※※-omg0009-c ■ dimensions ○body dimensions ○mounting by bracket.

  • Page 16

    No.Ps※※-omg0009-c revision history a: complete revision. B: limited warranty and disclaimer and measurement laws are added. C: modified errors in text. [july 2016] 4-14-1, sotokanda, chiyoda-ku, tokyo 101-0021 japan tel: + 81 3 5207 8249 fax: +81 3 5298 5362 url http://www.Smcworld.Com note: specifi...