SprotDog Pro hunter 2525 Operating Manual - Transmitter

18

1-800-732-0144

TO MANUALLY PROGRAM THE REMOTE TRANSMITTER’S ID CODE FOLLOW THESE STEPS:

1 . Turn the intensity dial to level 9, fl ip the toggle switch up, and then press and release the mode 

button on the back of your Remote Transmitter. This does not change the mode, so the current mode 

  will still be active after the ID change is complete.

2 . Once the mode button is released, the green indicator light will illuminate and stay on for 

 15 

seconds. 

3 . While the green light is on, turn the intensity dial to select the 1st digit of the ID, using 1-9,  and  

  then press and  release the top button. The green light will fl ash rapidly confi rming selection. 

4 . Again, while the green light is on, turn the intensity dial to select the 2nd digit of the ID, using 1-9,   

  and then press and release the top button. The green light will fl ash rapidly confi rming selection. 

The 2nd digit is optional, and if not desired, just wait until the green light turns off and refrain from 

  pressing the top button.

5 . At the end of 15 seconds, or after the second press of the top button, the green light will turn off 

  and the ID of the unit will be updated. At this point, the unit will be in the same mode it was 

  in prior to setting the ID. 

6 .  Upon changing the ID Code, you will need to match the Collar Receiver to the Remote Transmitter. 

  See Step 6 below.

NOTE: If you press the top button only once (skipping Step 4) the ID is still a two digit ID. The left 

digit is defaulted to 1. For example, if you selected 6 in Step 3 and pressed the button only once, the 

ID you get will be 16. 

To return the unit to the factory ID follow these steps:

1 . Turn the intensity dial to level 9, fl ip the toggle switch up, and then press and release the mode 

button on the back of your Remote Transmitter. This does not change the mode, so the current mode 

  will still be active after the ID change is complete.

2 . Do not press any buttons and wait until the green indicator light turns off.

3 .  You will now need to match the Collar Receiver to the Remote Transmitter. See Step 6 below.

MATCH THE COLLAR RECEIVER AND REMOTE 

TRANSMITTER

To reset the Collar Receiver to work with a new Remote Transmitter or to reprogram a new Collar 

Receiver to work with your existing Remote Transmitter:

1. Flip the toggle switch on your Remote Transmitter to the 

up

 position.

2. Turn the Collar Receiver off.

3. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after 4-5 

seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin fl ashing 

as  normal. If this occurs, start over and repeat from 

(2)

.

4. After the Receiver Indicator Light has turned off, release the On/Off Button. 

5.  Press and hold the Top Button on the Remote Transmitter until the Receiver Indicator Light fl ashes 

5 times. You may need to hold both units 2-3 feet from each other before this occurs. Once the 

Receiver Indicator Light has fl ashed 5 times, the Collar Receiver has been reset and will begin 

fl ashing as normal. If the Receiver Indicator Light does not fl ash 5 times, start over and repeat 

from 

(1)

.

ST

E

P

::

06