SPT RF-164SS Instruction Manual - page 7
5
4. OPERATION
4.1 Switching On Your Unit
•
Before connecting the unit to power supply, please make sure the thermostat control
dial is set at OFF position. The control is located to the right of the freezer box.
•
Connect power.
•
Adjust the thermostat control dial to the desired position, bear in mind that the
higher the number, the colder the temperature. The unit may not operate at the
correct temperature if it is in a particularly hot or a particularly cold room, or if the
door is opened frequently.
•
During initial use, please give your unit time to cool down completely before adding
food. It is best to wait for 24 hours.
4.2 Noise Inside the Unit!
You may notice that your unit makes some unusual noises. Most of these are perfectly normal,
but you should be aware of them!
These noises are caused by the circulation of the refrigerant in the cooling system. It has become
more pronounced since the introduction of CFC free gases. This is not a fault and will not affect
the performance of your unit. This is the compressor motor working, as it pumps the refrigerant
around the system.
4.3 Tips for Keeping Food in the Unit
•
Cooked food should always be stored on a shelf above raw meats/fishes to avoid bacteria
transfer. Keep raw meats/fishes in a container that is large enough to collect juices and
cover it properly. Place the container on the lowest shelf.
•
Leave space around your food to allow air to circulate inside the unit. Ensure all parts of
the unit are kept cool.
•
To prevent transfer of flavors and drying out, pack or cover the food separately. Fruits
and vegetables do not need to be wrapped.
•
Always allow pre-cooked food to cool down before placing inside the unit. This will help
to maintain the internal temperature of the unit.
•
To prevent cold air escaping, try to limit the frequency of door opening.
5. CLEANING
5.1 Defrosting
Frost may accumulate on the inner rear surface of the appliance, which
will automatically defrost during the cycle of the compressor. Water is
channeled via the drain hole to the collection tray above the
compressor where it will evaporate.
Please ensure the drain hole is checked and cleaned on a regular basis
so water can exit the storage compartment.