SPT WA-9010E Instruction Manual - page 13
USE OF CONTROL PANEL
10
WATER DRAINAGE
WATER DRAINAGE METHODS
fig. 1
TIMER SETTING
To set time to start the unit when power is off (but with power supplied):
1. Press " " button, the LCD window will show " ".
2. Press the TIME button and set the number of hours you wish to start running the unit. For
example, if you wish to have the unit start in 8 hours, press the TIME button repeatedly
until 8 hours is indicated.
To set time to stop the unit when unit is running:
1. Press " " button, the LCD window will show " ".
2. Press the TIME button to set the desired time to stop the unit. For example, if you wish to
have the unit stop in 5 hours, press the TIME button repeatedly until 5 hours is indicated.
NOTE: The time range for timer on or off is between 1 ~ 12 hours.
AUTO SWING FUNCTION
1. Press " " button and LCD window will show " ". Louver will begin to swing
automatically.
2. Press " " button again and " " in the LCD window will disappear, swinging will stop.
LOCKING THE KEY PAD
Press " " and " " buttons together and hold for more than two seconds will lock the
keypad. LCD window will show " ". Press the two buttons together again will unlock the
keypad and the symbol " " will disappear.
When in cooling or dehumidifying mode, the condensation will drain into the
tank. When the tank gets full, the WATER FULL indicator will flicker. As shown in
the Fig. 1, 2 and 3, pull out the water tank, pour out the water inside the tank,
then push it back to its original position.
ON
OFF
+
-