SPX ACCUTORQ 7375 Operating Instructions
Sheet No.
Issue Date:
Litho in USA
ACCUTORQ™
CLIKKER TORQUE WRENCHES
The Clikker Torque Wrenches are torque-limiting tools. A steel case encloses a power spring, a torque signaling
mechanism, a ratchet drive tang at the head of the case, and an adjustable hand grip (with lock) in the handle. The case
and grip have a calibration scale that is set and read like a micrometer.
OPERATING INSTRUCTIONS
Setting the TORQUE
The following example demonstrates how to set a torque of 64 ft. lbs.
1. Unlock the handle by holding the tube and firmly pulling the handle back. See Figure A.
NOTE: Keep pressure (a rearward pull) on the handle during Steps 2 and 3.
2. Align the thimble edge with the “60” graduation cross line on the tube. Align the zero (0) on the thimble with the vertical
line on the tube. See Figure B.
The wrench is now set at 60 ft. lbs.
3. By turning the handle, align the four (4) on the thimble with the vertical line on the tube. See Figure C.
The wrench is
now set at 64 ft. lbs.
4. Push the handle forward until it clicks into the lock position. NOTE: The handle will lock only when a line on the
thimble is in line with the vertical line on the tube. See Figure D.
Form No. 105152
Operating Instructions
for:
7375
7377
7378
7379
HANDLE
THIMBLE
MAJOR
GRADUATIONS
TUBE
MINOR
GRADUATIONS
FIGURE A
Handle in the Unlocked Position
FIGURE B
Set at 60 ft. lbs.
FIGURE C
Set at 64 ft. lbs.
1 of 2
Rev. 5-1-98
190
170
150
130
110
90
70
50
200
180
160
140
120
100
80
60
2
0
8
LB. FT.
6
4
2
190
170
150
130
110
90
70
200
180
160
140
120
100
80
60
LB. FT.
SPX Corporation
655 Eisenhower Drive
Owatonna, MN 55060-0995 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7290
Fax: (507) 455-7063