Spy Tec Mobius Instruction Manual - page 9
allowed and which are not allowed. If you edit the SYSCFG.TXT and enter invalid values
the results are undefined and will lead to unexpected results.
Using Software to configure the camera
The Windows program mSetup.exe will automatically configure the camera with the
parameters you require. Detailed instructions can be found in the program by clicking the
"Help" button. The program is also used to synchronize the camera's internal clock with the
computer's date and time.
►An official configuration tool which will work with many Android devices can be found in
Google's Play Store. Search for "therau2000" to list programs by this author.
Firmware Update
New firmware versions usually correct issues found in previous versions but often provide
new functionality which was not previously available. It is good practice to keep your
camera updated with the latest firmware version. You can upgrade or downgrade your
firmware as often as you wish. Both procedures are identical and are referred to as
'updating' in this manual.
The latest firmware version can be downloaded and installed directly from the setup
program or installed manually by downloading the firmware file from
http://www.rcgroups.com/forums/showpost.php?p=25170908&postcount=3.
Updating the firmware is an easy and safe process, but you should take note that it is not
possible to update the firmware using SD cards with a capacity greater than 32GB unless
they are formatted to FAT32. The firmware update routine is a low-level routine called
before the exFAT file system is loaded. The low-level routine only supports the FAT32 file
system.
Automatic Firmware Update
Use mSetup (Tools) to automatically update the firmware. This is by far the easiest
method.
Manual Firmware Update
DO NOT PRESS ANY BUTTONS during the firmware update process.
There are two methods with which you can update the firmware.
Method 1 without pressing any buttons:
•
Turn off the camera.
•
Connect the camera to the computer and wait until the card is recognized as a
Removable Drive.
•
Copy the new firmware file into the camera's flash card root folder. All firmware files
are named FWTLCAM.BIN. The name must not be changed.
•
Disconnect the camera from the computer and wait until it turns off.
•
Wait until all the LEDs are turned off.
•
Connect the camera to the PC. The blue LED will turn on for about 13 seconds and
then begin to flash.
WAIT
.
•
After another 7 seconds the blue LED will turn off.
WAIT
.
•
After a second or two the yellow LED will turn on.
WAIT
•
The firmware file will be automatically deleted.
•
The camera will automatically be connected as a removable device.
•
After about 4 seconds the process is complete and the yellow LED will turn off.
•
The camera is now ready for use as a USB drive.