Ssl SOUNDSTORM User Manual

Summary of SOUNDSTORM

  • Page 1

    Precaution before operating the unit, read this manual thoroughly and keep it handy for future reference . To avoid injury or accident , read the following precautions before installing and operating the unit . Thank you for purchasing a soundstorm multimedia player . About the liquid crystal displa...

  • Page 2: Safety Information

    Safety information caution: this digital video player is a class i laser product. However this digital video player uses a visible/invisible laser beam which could cause . Hazardous radiation exposure if directed. Be sure to operate the digital video player correctly as instructed. Use of controls o...

  • Page 3: Disc Note

    Disc note preparing new discs with rough spots a new disc may have rough edges on its inside and outside edges. If a disc with rough edges is used, the proper setting will not be performed and the player will not play the disc. Therefore, remove the r o u g h e d g e s i n a d v a n c e by using a b...

  • Page 4: Installation

    Notes: choose the mounting location where the unit will not interfere with the normal driving function of the driver. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. Use only the parts include...

  • Page 5: Installation

    1. Remove the chassis from slide bracket housing; 1) press the rel button to release the control panel ; 2) hold the right side of the control panel to pull it rightwards a little and then to you for removing it ; 3) remove the plastic frame from the chassis (see the installation diagram); 4) insert...

  • Page 6: Installation

    Installation hollow bulge 1 2 2) attaching the control panel onto the chassis; (1) insert the left side of the control panel into the hollow of the chassis . (note : the “bulge” point on the control panel must be attached into the hollow of the chassis .) (2) gently push the right side of the contro...

  • Page 7: Installation

    Installation installation diagram if you want to take chassis out of the slide bracket housing, first remove the plastic trim out of the both sides away, then insert the two key plate into left and right side of chassis as above illustration. Dash board metal mounting strap hex nut spring washer pla...

  • Page 8: Installation

    Installation installing the monitor. 1) press the open/monitor-angle button to slide the monitor holder out and stand it up. 2) insert the 2 bulges of the monitor into the 2 hollows of the monitor holder and flip up the monitor, then push the top middle part of the monitor to make the monitor attach...

  • Page 9: Electric Connection

    Electric connection wiring connection note: the ground connection cable (parking brake b-) must be connected in order for pictures to be played back to the monitor. If the cable has not been correctly connected, appears on the monitor. Warning message violet/white (b+)12v rear camera switch (b-)park...

  • Page 11: Remote Control

    1. Removing insulating sheet if ) ) ) . ) ) ) . ) ) using remote control for the first time, you can see an insulating sheet at the bottom side of remote control as right. You must remove the insulating sheet as right. Otherwise, the remote control is disabled. 2. Replace lithium cell if the electri...

  • Page 12: Basic Operation

    Basic operation main menu operation in many modes, touch the icon or touch the range to enter the main menu, the message like following as below. General setup interface2 general wallpaper ... Bluetooth on about ... 1. Power icon in any modes, touch the power icon to switch the unit off . The monito...

  • Page 13: Basic Operation

    Basic operation format tv type this is to select the appropriate tv aspect (4:3 or 16:9) according to the connected tv set. Normal/ps (for 4:3 tv) played back in the pan & scan style. (if connected to wide-screen tv, the left and right edges are cut off.) normal/lb (for 4:3 tv) played back in letter...

  • Page 14: Basic Operation

    Basic operation the reset button is to be activated for the following reasons: a. Initial installation of the unit when all wiring is completed. B. All the function buttons do not operate. C. Error symbol on the display. Rear view camera when connecting the rear view camera the mirror image of the r...

  • Page 15: Control Panel

    button 14. Sd/mmc card slot 15. Lcd sreen 16. Open button 17. ...

  • Page 16: Control Panel

    Control panel same functions in any work source 1. Power button and icon in power off mode, pressing power button on remote control or pressing power button on control panel powers on main unit. In power on mode, long pressing power button on control panel or on remote control or touch icon on sourc...

  • Page 17: Touch Screen Operation

    Touch screen operation selecting the frequency band touch the screen of “ band ” section repeatedly to select the band , the message will show in turn : when an fm stereo broadcast is hard to receive press st/mo button on the remote control to select the mono or stereo mode . Start searching for a s...

  • Page 18: Touch Screen Operation

    Touch screen operation radio rds pi mute rds ta off rds af off automatic memory storing & program scanning 3 rds function adjustable items: automatic preset setup in radio mode, touch and keep (for more than 2 ’ s) the screen of “ ” range to active automatic station storage. The radio searches withi...

  • Page 19: Touch Screen Operation

    Ta traffic announcement (priority for traffic information) when the ta function is activated, the ta symbol appears in the display . During radio operation in one fm frequency band the search for a traffic announcement station is started automatically (ta seek) . If an fm station is being received w...

  • Page 20: Media Operation

    Media operation in audio play mode, the message will display as below : (when parking brake is applied .) touch screen operation to skip the next track to skip the previous track repeat function random function previous menu tap to turn to bt phone mode. (after pairing and connecting a mobile phone ...

  • Page 21: Touch Screen Operation

    Touch screen operation for digital video : tap the icon or press the rpt button on the remote control to select repeat mode as follows : rep eat all chapt er rep eat on ti tl e rep eat on rep eat off press up to invert an image . Press down to mirror an image . Press left to rotate an image to left ...

  • Page 22: Touch Screen Operation

    Touch screen operation note: when select the intro mode, this player to start to play the previous 15 seconds part of each track/chapter on disc. (touch it again to cancel this mode .) 3). Rdm(random) function during disc playback, touch screen of “ ” section ( press the rdm button on the remote con...

  • Page 23: Touch Screen Operation

    Touch screen operation the screen will display the following message : touch the to select the your adjustment item, then select the item your favour by touching the numberic buttons , then touch the ok button to confirm . For movie/photo: touch the screen as show or press the goto button on remote ...

  • Page 24: Touch Screen Operation

    Touch screen operation digital video special function 4. Title menu function for digital video: if the digital video has multiple titles recorded on the disc. It can select preferred title from the title menu to start playback. - during digital video playback, press title button on the remote .The t...

  • Page 25: Touch Screen Operation

    Touch screen operation bt operation 1. Pairing and connecting prior to using the bt device named ssl as a hands-free system for a bt-enabled mobile phone for the first time, you must as follows: press the bt hands-free icon or press the pair button on the remote control to turn to bt standby mode as...

  • Page 26: Touch Screen Operation

    Touch screen operation user swf user swf bt music bt music b. Use the number icons or buttons to input your desired phone number; * when inputting a wrong digit, use icon or c. After finishing inputting, touch icon or press button on control panel to dial out. 2) redial last dialed phone number touc...

  • Page 27: Touch Screen Operation

    ) using your mobile phone with bt function to audio/video if it the audio of the mobile phone will change into . The ssl supports a2dp, which enables the user to stream audio from their device. ) t bt the car a/v system so these icons on the bt music interface except bt music and their buttons on co...

  • Page 28: Touch Screen Operation

    Touch screen operation aux operation on the front panel of this unit, there is an aux in jack, follow the diagram below to connect analogue replay devices(only for the audio connect, if you want to connect the video, please plug the on the back of the unit .) . Use this jack to replay sound of other...

  • Page 29: Touch Screen Operation

    Touch screen operation av operation please plug the on the back of the unit . Touch the av in icon to enter the av in mode. The function of the icons as follow: tap to mute the sound. Tap to select eq as the same on the remote control. Tap to turn loud on or off. Tap to select subwoofer frequency. T...

  • Page 30: Touch Screen Operation

    10:00 am 5 current play track . Touch screen operation following the diagram below, connect your usb device to the front panel usb port . If it is properly connected, the device will be mounted and start playing automatically. Usb operation 1 current type (highlighted bar) . 2 audio play mode select...

  • Page 31: Touch Screen Operation

    10:00 am touch screen operation steering wheel control touch the swc icon as follow to turn to steering wheel control . During setting, touch the icon to turn to home menu. There are 2 key for total 12 buttons to save, first, tap assign to open function save, then select button 1 in key 1 on steerin...

  • Page 32: Parental Control

    Parental control * parental control q: after inserting a digital video disc into the disc slot, ? A: the playing disc is locked by a rating level of parental control. If the current rating level of parental control of the digital video player is lower than the one of current disc, you must input the...

  • Page 33: Region Code For Dvd

    Region code for dvd * region code appendix: region code of d motion picture association of america (mpaa) divided the world into 6 regions, and gave every region a region code for locking and unlocking d playback. Please region codes and the countries or areas represented by region codes are as foll...

  • Page 34: Specification

    Specification general power supply requirement..................................................Dc 12v current consumption........................................................10a max. Audio signal output ............................... Front, rear, and subwoofer output frequency response ...........

  • Page 35: Troubleshooting

    Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Troubleshooting inserting the disc in reverse direction press the reset button. Front panel is not properly fixed into its place the car i...