1 instruction manual double insulation important: read before using. Power planer mkp082 011863.
2 english (original instructions) specifications model mkp082 planing width 82 mm planing depth 2 mm shiplapping depth 9 mm no load speed (min -1 ) 16,000 overall length 285 mm net weight 2.7 kg safety class /ii • due to our continuing programme of research and development, the specifications herein...
3 7. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. 8. When operating a power tool outdoors, use an extension cord suitable for o...
4 could give the operator an electric shock. 3. Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body leaves it unstable and may lead to loss of control. 4. Rags, cloth, cord, string and the like should never be le...
5 caution: • do not pull the switch trigger hard without depressing the lock-off button. This can cause switch breakage. Foot 1 2 3 011866 after a cutting operation, raise the back side of the tool and a foot comes under the level of the rear base. This prevents the tool blades to be damaged. Assemb...
6 for tool with mini planer blades 1 2 011867 1. Remove the existing blade, if the tool has been in use, carefully clean the drum surfaces and the drum cover. To remove the blades on the drum, unscrew the three installation bolts with the socket wrench. The drum cover comes off together with the bla...
7 for the correct planer blade setting your planing surface will end up rough and uneven, unless the blade is set properly and securely. The blade must be mounted so that the cutting edge is absolutely level, that is, parallel to the surface of the rear base. Refer to some examples below for proper ...
8 operation hold the tool firmly with one hand on the knob and the other hand on the switch handle when performing the tool. Planing operation 1 2 011869 first, rest the tool front base flat upon the workpiece surface without the blades making any contact. Switch on and wait until the blades attain ...
9 chamfering 003634 011873 to make a chamfering cut as shown in the figure, align the "v" groove in the front base with the edge of the workpiece and plane it. Maintenance caution: • always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. • ...
10 1 2 011875 use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. To maintain product safety and reliability, repairs, any other maintenance or adjustment should be performed by makita authorized service centers, ...
11.
12 makita corporation anjo, aichi, japan www.Makita.Com 885032-931.
