SSV Embedded Systems System-on-Module eSOM/2586 Hardware Reference Manual - page 5
System-on-Module eSOM/2586 - Hardware Reference
B o a r d R e v i s i o n 1 . 0 / M a n u a l R e v i s i o n 1 . 1
5
1.4
Features and Technical Data
•
Vortex86DX 32-bit x86 SoC @600, 800, 1.000 MHz Clock Speed (please see note 1)
•
PC-compatible AMI Basic I/O System (BIOS)
•
128 MByte SDRAM with DDR2 interface @300 MHz Bus Speed
•
1 GByte NAND FLASH Memory for O/S Boot Image and Data Files
•
XGI GPU VGA controller with 64 MByte Frame Buffer (DDR2 SDRAM)
•
On-board PCI Interface between Vortex86DX SoC and XGI GPU
•
18-bit TTL Color LCD Interface for TFT and STN panels
•
4-wire Touch Screen Interface (please see note 2)
•
1x CompactFlash (CF) Card Slot with IDE-based Interface
•
1x LED for IDE (CF) Access Status
•
1x 10/100 Mbps Ethernet LAN Interface
•
1x LED Output Signal for LAN Status
•
2x USB 2.0 Host Interface with HS, FS and LS support
•
1x SPI (Serial Peripheral Interface) with one Chip Select Output (please see note 3)
•
3x 16C550/16C552-compatible UART-based Serial Ports (one with all Handshakes)
•
16-bit General Purpose Parallel Input Output (GPIOs) (please see note 3)
•
16-bit Expansion Bus with 24 Address Lines
•
4x Interrupt Inputs, 4x Chip Select Outputs
•
Programmable Watchdog Timer
•
In-System Programming Features
•
2x 100-pin Hirose FX8C Interface Connector
•
3.3 Volt Low Power Design, Supply Voltage 3.3 VDC (±5 %)
•
Supply Current 1.000 mA typ. @800 MHz (1.300 mA max.)
•
0 °C to +70 °C Operating Temperature (still air) without Heat Sink
•
Size 80 mm x 50 mm
•
Preinstalled Linux O/S with Kernel Version 2.6.18 or ROM-DOS 6.22 O/S
•
RoHS compliant
Note 1: The ex factory clock speed is 800 MHz. The other clock speeds are available
over an on-board strap option.
Note 2: The software interface of the eSOM/2586 4-wire touch screen interface is
available over an on-board UART.
Note 3: The four SPI signals of the eSOM/2586 can be also used as a 4-bit GPIO
(GPIO – Parallel Port C).