ST EVALSPEAr300 User Manual

Summary of EVALSPEAr300

  • Page 1

    February 2010 doc id 16303 rev 2 1/25 um0804 user manual evalspear300 - evaluation board for the spear300 1 description the evalspear300 evaluation board for spear300 is intended to be used for three main purposes: ■ to allow you to quickly evaluate and debug software for the spear300 ■ act as a lea...

  • Page 2: Contents

    Contents um0804 2/25 doc id 16303 rev 2 contents 1 description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 2 contents of the kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 3 connectors locations . . ...

  • Page 3

    Um0804 contents doc id 16303 rev 2 3/25 6.9 general power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 6.10 general-purpose i/os . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 6.11 reset switch . . . . . . . . . . . . . ....

  • Page 4: List of Tables

    List of tables um0804 4/25 doc id 16303 rev 2 list of tables table 1. Switch 2 bits [2:1] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 table 2. Switch 2 (soc functional configuration) . . . . . . . . . . . . . . . . . . . . . . . ...

  • Page 5: List of Figures

    Um0804 list of figures doc id 16303 rev 2 5/25 list of figures figure 1. Evalspear300 evaluation board . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 figure 2. Connectors locations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Page 6: Contents of The Kit

    Contents of the kit um0804 6/25 doc id 16303 rev 2 2 contents of the kit the evalspear300 evaluation board kit contains: ● spear300 evaluation board ● ac/adapter (output voltage 5 v) ● 2 plug adapter (usa/europe) ● user manual documentation 3 connectors locations figure 2. Connectors locations manua...

  • Page 7: Features and Block Diagram

    Um0804 features and block diagram doc id 16303 rev 2 7/25 4 features and block diagram 4.1 features ● spear300 embedded mpu ● up to 2 gb ddr2 333 mhz (std 128 mb) ● up to 16 mb serial flash memory (std 8 mb) ● up to 2 gb nand flash memory (std 64 mb) ● 4 kb serial i 2 c ● 4 mb spi flash memory ● two...

  • Page 8: 5 Start

    Start up um0804 8/25 doc id 16303 rev 2 5 start up 5.1 unpacking electrostatic warning: the evalspear300 evaluation board is shipped in protective anti-static packaging. The board must not be subjected to high electrostatic potentials. General practices for working with static sensitive devices shou...

  • Page 9: 6 Block

    Um0804 block descriptions doc id 16303 rev 2 9/25 6 block descriptions 6.1 dynamic memory subsystem the dynamic memory subsystem is composed of three major parts: 6.1.1 memory chip the memory used is a micron ddr2 device and its part number is: mt47h64m16hr-3. Its size is 128 mb x 8 (16 mb x 8 x 8 b...

  • Page 10

    Block descriptions um0804 10/25 doc id 16303 rev 2 6.3 ethernet subsystem this subsystem is based on the ethernet phy ste100p (u9) and a connector (j9) that also includes also all the required magnetics (line transformer ratio 1:1). Several leds are present to indicate the status of the line: ● the ...

  • Page 11

    Um0804 block descriptions doc id 16303 rev 2 11/25 please refer to the documentation of the trace box manufacturer for more information on the etm interface (www.Lauterbach.Com, www.Agilent.Com, www.Yokogawa.Com). 6.6 serial interface one serial interface port is available. This typically used as os...

  • Page 12

    Block descriptions um0804 12/25 doc id 16303 rev 2 6.9 general power supply from a 5 v external ac/dc regulator power source, this block, generates all the required voltages as follows: ● 1.2 v (switching regulator pm6641) to supply the internal logic of the spear300 ● 1.8 v (switching regulator pm6...

  • Page 13: 7 Jumper

    Um0804 jumper settings doc id 16303 rev 2 13/25 7 jumper settings 7.1 switch 2 note: when dip switch sw2-x is in the on position, the bit value is 0. When the dip switch is in the off position, the bit value is 1. Bits 3, 4, and 5 allow you to set the functional configuration. The default configurat...

  • Page 14: 8 Expansion

    Expansion connector um0804 14/25 doc id 16303 rev 2 7.2 switch 3 note: when dip switch sw3-x is in the on position, the bit value is 0. When the dip switch is in the off position, the bit value is 1 8 expansion connector an expansion connector (j12 on bottom side) is provided for a companion board. ...

  • Page 15: 9 Evaluation

    Um0804 evaluation board bill of materials (bom) doc id 16303 rev 2 15/25 9 evaluation board bill of materials (bom) reference: spear300 bom board rev1 (set. 17 2009) table 6. Capacitors # qty ref. Description value manufacturer manufacturer p/n 1 1 b1 panasonic br/cr2032/1gvf1gv 2 58 c1, c2, c3, c4,...

  • Page 16

    Evaluation board bill of materials (bom) um0804 16/25 doc id 16303 rev 2 table 7. Connectors, inductors and transistors # qty ref. Description value manufacturer manufacturer p/n 20 1 j1 usb_device samtec usb-b-s-f-b-th 21 1 j2 usb_host tyco electronics amp 5787617-1 22 1 j3 a2d conn. Tyco electroni...

  • Page 17

    Um0804 evaluation board bill of materials (bom) doc id 16303 rev 2 17/25 72 1 u8 m25p40 stm m25p40-vmn6p 73 1 u9 ste100p stm ste100p 74 1 u10 st3232-so16 stm st3232cdr 75 1 u11 pm6641 stm pm6641 76 1 u12 ld1117s25tr stm ld1117s25tr 77 1 y1 24mhz rakon xtal003325 78 1 y2 32.768khz fox electronics nc2...

  • Page 18

    Evaluation board bill of materials (bom) um0804 18/25 doc id 16303 rev 2 53 5 r87, r88, r89, r90, r91 150 tyco electronics uk crg0603f150r 54 7 r92, r93, r94, r95, r96, r97, r98 68k tyco electronics uk crg0603f68k 55 1 r99 27k tyco electronics uk crg0603f27k 56 3 r81, r100, r101 150k tyco electronic...

  • Page 19: Appendix A

    Um0804 licence agreements doc id 16303 rev 2 19/25 appendix a licence agreements demo product license agreement by using this demonstration product, you are agreeing to be bound by the terms and conditions of this agreement. Do not use this demonstration product until you have read and agreed to the...

  • Page 20

    Licence agreements um0804 20/25 doc id 16303 rev 2 like) whether based on contract, tort, or any other legal theory, relating to or in connection with the demo product, the documentation or this agreement, even if st has been advised of the possibility of such damages. In no event shall st's aggrega...

  • Page 21

    Um0804 licence agreements doc id 16303 rev 2 21/25 software license agreement this software license agreement ("agreement") is displayed for you to read prior to downloading and using the licensed software. If you choose not to agree with these provisions, do not download or install the enclosed lic...

  • Page 22

    Licence agreements um0804 22/25 doc id 16303 rev 2 you will inform all your employees who are given access to the source code of the licensed software of the foregoing requirements, and you will take all reasonable precautions to ensure and monitor their compliance with such requirements. You agree ...

  • Page 23

    Um0804 licence agreements doc id 16303 rev 2 23/25 severability if any provision of this agreement is or becomes, at any time or for any reason, unenforceable or invalid, no other provision of this agreement shall be affected thereby, and the remaining provisions of this agreement shall continue wit...

  • Page 24: Revision History

    Revision history um0804 24/25 doc id 16303 rev 2 revision history table 10. Document revision history date revision changes 25-sep-2009 1 initial release. 25-feb-2010 2 updated figure 4 . Corrected code names in section 6.12: lcd interface . Changed the title of section 6.13: sdio interface . Update...

  • Page 25

    Um0804 doc id 16303 rev 2 25/25 please read carefully: information in this document is provided solely in connection with st products. Stmicroelectronics nv and its subsidiaries (“st”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products a...