ST UM2205 User Manual - page 6
Getting started
UM2205
6/21
DocID030539 Rev 1
The NUCLEO-F072RB board includes:
an STM32F072RBT6 32-bit microcontroller based on ARM
®
Cortex
®
-M0 with 128-
Kbytes of Flash memory, 16-Kbytes of SRAM and a USB 2.0 full speed data interface
in a LQFP64 package
extension resources:
Arduino Uno revision 3 connectivity
ST morpho extension pin headers for full access to all STM32 I/Os
on-board ST-LINK/V2-1 debugger/programmer with SWD connector:
selection-mode switch to use the kit as a standalone ST-LINK/V2-1
flexible board power supply:
USB VBUS on Type-B connector or external source
Power management access point
LEDs:
USB communication (LD1)
user LED (LD2)
power LED (LD3)
push buttons:
USER
RESET
USB re-enumeration capability; interfaces supported on USB:
Virtual Com port
Mass storage
Debug port
Supported by various integrated development environments (IDEs):
IAR™
Keil®
GCC-based IDEs
The NUCLEO-F072RB included in the kit has a different solder bridge
configuration with respect to the default one (see
Table 1: "Solder bridges and
resistors to be modified"
)
1.2
NUCLEO-F072RB STM32 Nucleo board
The STM32 Nucleo board provides an affordable and flexible way for solution and
prototype development with any of STM32 microcontroller lines.
The board STM32F072RBT6 32-bit microcontroller is based on the ARM
®
Cortex
®
-M0 with
128 Kb Flash memory and 16 Kb SRAM.
The Arduino™ connectivity support and ST morpho headers make it easy to expand with a
wide range of specialized expansion boards.
Separate probes are not required as it integrates the ST-LINK/V2-1 debugger/programmer.
The STM32 Nucleo board comes with the comprehensive STM32 HAL software library
together with various packaged software examples.
Visit
http://www.st.com/stm32nucleo
for more information.