Suttle SOHO Access SAM-V8 Installation Instructions

A

Brown

White/Brown

Green

White/Green

Orange

White/Orange

Blue

White/Blue

SOHO Access

TM

8-Port Voice Module

Installation Instructions

SAM-V8: 

8-port voice module

Mount module to enclosure backboard

a) Position module with mounting pins aligned to grid holes.

b) While holding the module in place, pull each pin plunger OUT then

   fi rmly push the plunger IN to secure the module to the backboard.

Terminate incoming service lines from Telco

a) Route twisted pair cable from the telephone company demarcation 

   point to the 110 IDC connector LINE IN. 

b)  Follow the 110 IDC wire termination procedure.

c)  Connect tester to the OUT jack and verify incoming dial tone.

Terminate premise wiring

a)  Route twisted pair cable from the numbered 110 IDC’s to the 

   telephone jacks throughout the premise.  

b)  Follow 110 IDC wire termination procedure.

c)  Record wiring information on the designation label inside

   enclosure   cover.

Test premise wire connections

 Connect tester to each outlet jack and verify dial tone.  

Note: Use a qualifi cation tester equipped with an RJ45

(8 position, 8 conductor) test plug.

1

2

3

A

■

8-port voice module

■

Designation label

■

Instructions

Package Contents

B

4

A

110 IDC Wire Termination Procedure

a) Strip 3 in of outer jacket from the cable.

b) Insert wires into color coded slots as 

   shown below. Insert the white/blue wire

   in the white slot and blue wire in the 

   blue slot.  Repeat with the orange, green 

   and brown wires.

c) Terminate wires with a punch-tool and 

   trim excess with a diagonal cutter.

B

1

3

3

3

3

1

2