Sven AP-880 User Manual - Installed.
INSTALLATION AND OPERATION GUIDE
• Installation of batteries. Open the battery compartment cover d,
observing polarity, install two AAA-type batteries (not included), close the
compartment.
• Volume control. Turning the control wheel b, set the necessary volume
level.
• Vibration subwoofer level switch. Using the slide switch a, select the
vibration subwoofer operation mode:
OFF: vibration subwoofer function and LED c are off, the headphones
reproduce sound without vibration.
I: vibration subwoofer function is on, the LED c is on, vibration level is weak.
II: vibration subwoofer function is on at maximum level, the LED c is on,
vibration level is strong.
Note. The vibration subwoofer doesn’t operate without batteries
installed.
TECHNICAL SPECIFICATIONS
Parameter, measurement unit
Sensitivity, dB
Frequency range, Hz
Membrane, mm
Connector type
Cable length, m
Weight, g
Value
headphones: 100 ± 4
microphone: -60 ± 3
headphones: 20 – 20,000
microphone: 40 – 18,000
Ø 40
Ø 2*3.5 mm (3 pin) stereo mini jack
2.4
295
Notes:
• Technical specifications given in this table are supplemental information
and cannot give occasion to claims.
• Technical specifications are subject to change without notice due to
improvement of SVEN production.
Technical support is on сайтe www.sven.fi.
ENG
2