Sven X-PAD AERO Operation Manual - Eng
Fig. 4
Fig. 5
7. CONNECTION AND INSTALLATION
• Connect the gamepad via USB cable b to an
available USB port of your PC. After connection to
your PC, the device is automatically detected as a
game controller and is fully ready for use.
However, for Vibration Feedback function it is
necessary to install drivers. Calibration of the
second joystick is also impossible without the
installation of drivers.
•
Insert Software CD disk into your PC CD-Rom
and start setup.exe for installation of drivers. For
testing and setting the game controller choose
Start → Control Panel → Game Controller. There will
open up Properties: PC TWIN SHOCK (see Fig. 4)
on your desktop.
•
Click Function Test (Fig. 4) to test axes and
buttons.
• Enter Calibration Function (Fig. 5) to calibrate all
four axes.
• Enter Vibration test (see Fig. 6) to test and to set
Vibration Feedback function:
a) increase or reduce Vibration strength by moving
cursor. For example: vibration strength is 85 % in
Fig. 6;
b) test Vibration Feedback function on the left
or/and right motors by pressing Left force, Both
force and Right force;
c) after setting and testing press ОК (confirm) in
the bottom of the window.
Note! Vibration Feedback function is always
on when there is illumination of RUMBLE
button f . To turn off Vibration Feedback
function, press RUMBLE button and its illumi-
nation will be off.
4