SVT -IP System B User Manual - page 9
-7-
6.2 RJ45 Ethernet Cable Connection
If you are installing the SVT-IP Outdoor Station in a place out of the range of your
Wi-Fi network, you may use the RJ45 Ethernet cable connection instead.
You must first connect it to the Wi-Fi network following the instructions on pages 5
or 6. Do not remove the antenna until the RJ45 Ethernet cable connection is
completed.
Step 1: Login to your router setting page to find the IP address and the Gateway of
the SVT-IP Outdoor Station.
Step 2: Open Internet Explorer on your pc and type the IP address into the Address
Bar to open the "IP Camera login page".
Step 3: Login using the same default user name (admin) and password (1234) as
the ControlCam App.
Step 4: Select "Config." - "Network Settings" - LAN, and set the IP address and
Gateway the same as your LAN network. Select "Save" to complete the new settings.