Assembly instructions for c-95003w mega bench 090102 insert cross bar head hinge body (3) (3) (2) (4) (2) (4) (2) foot hinge/seat assembly optional leg curl/ext. Attachment shown here for information only t.D.S. Fitness equipment p.O. Box 4189 elmira, ny 14904, usa 607-733-6789 this equipment design...
95003-mega bench drawing # 1 hinge (1) rear seat front seat drawing # 2 090102 (1) front hinge, rear hinge and the slide are pre-assembled. Tighten the bolts after competing the whole assembly page 2 of 6.
Page 3 of 6 c-95003 mega bench - assembly instruction this unit requires (1) 9/16 wrench and (1) 11/16 wrench for assembly. Do not tighten hardware until instructed to do so. Do not over tighten. 01) turn front seat and rear seat upside down on level surface. Attach hinge to front and rear seat with...
Once you complete the assembly make sure to check the following points carefully before starting your workout. 1. All the hardware should be checked for tightness. 2. All sliding assemblies should be checked for alignment. 3. Locks and pins should be in place to avoid slipping. 4. Cable ends and joi...