T&J Monocoupe 90A Assembly Instructions Manual - page 7
Manual is about: R/C Model Designs By Jim Young
of
11
Monocoupe 90A
Page 7 Copyright © 2016 Jim Young and T& J Models
Glue SC to front of F1 and sand to
shape.
Cut the door free and hinge each with
two Robart hinge points.
Glue together and laminate the three
cowl rings CR1, CR2, and CR3.
Laminate 8 pairs of C4 from 1/8” balsa.
Assemble the cowl structure. Plank the
cowl with 1/16” or 3/32” balsa. Glue the
cowl rings on the front and sand smooth.
Two layers of 1/8” balsa are sanded to
shape for the engine crankcase.
A template (7 cylinder, equally spaced)
is provided for the cowl blisters. Cowl
blisters can be sanded prior to or after
gluing in place. The cowl is held in
place with three screws through C1 into
the firewall.