T L Audio EQ-3011 User Manual - page 6
Balanced Outputs.
The output is via a balanced, 3 pin male XLR connector. The mating connector
should be wired as follows:
- Pin 1 = Ground (screen),
- Pin 2 = Signal Phase (“+” or “hot”),
- Pin 3 = Signal Non-Phase (“-” or “cold”).
Unbalanced Outputs.
An unbalanced line output is provided for each channel, on a 0.25” mono jack socket.
- Tip = Signal Phase (“+” or “hot”).
- Screen = Ground.
Mounting.
The equaliser may be free standing, or mounted in a standard 19” rack.
Do not locate the unit where it will be subject to external heating, for example in the
hot air flow from a power amplifier, or on a radiator.
Rear Panel.
The rear panel connectors are identified in fig.3. Make sure that all settings, mains and
audio connections have been made as described above before attempting to operate
the equipment.