T-Mobile 4G LTE CellSpot Quick Start Manual - Quick Setup
Quick Setup
1
2
3
4
4
3
2
1
3
GPS antenna
faces skyward
Connect your CellSpot to the Internet
Connect the yellow Ethernet cable from the “WAN” yellow
port on your CellSpot to an available Ethernet port on your
Wi-Fi router or Wi-Fi cable modem router.
To reduce device setup time, stop using high Internet
bandwidth consuming applications, such as video streaming,
during CellSpot device setup process.
Recommend a minimum Internet speed of 2 Mbps download
and 500 Kpbs upload for reliable product performance.
Connect GPS antenna to the CellSpot
Connect the GPS antenna cable to the GPS port. Position the
antenna as close to a window as possible.
Device can still proceed through setup without GPS antenna
connection. However, GPS antenna connection helps reduce
device setup time and improves device location accuracy.
Power on your 4G LTE CellSpot
Connect the power cable to the CellSpot power port, then
plug in your AC power adaptor into the power outlet.
Install the device stand or wall mount after all cable
connections are complete. This helps ensure the device has
sufficient ventilation.
Let your CellSpot set up
After you power on your CellSpot, the CellSpot will go
through a self-installation process. During this process, the
power LED will be in flashing green as the device
downloads the latest software and performs device location
verification. It can take up to 2 hours to complete the device
setup. Your CellSpot may restart a couple of times during this
process.
• Power (Solid Green): Power on. Device self testing and
update complete.
• Internet (Solid Green): Successful internet connection
complete.
• Status (Solid Green): Successful T-Mobile network
connection complete.
• GPS (Solid Green Optional): GPS position locked if GPS
signal is present. Device can still proceed through setup
without GPS signal lock and operate normally.
• 3G/4G (Solid Green): Device is ready to provide 3G/4G
service. When there is 3G/4G traffic in progress, 3G/4G
LED will be flashing green.
• 4G LTE (Solid Green): Device is ready to provide 4G LTE
service. When there is 4G LTE traffic in progress, 4G LTE
LED will be flashing green.
After device setup is complete, you can wrap the GPS
antenna and cable to the GPS cable bracket. Device will
continue to work if GPS antenna is removed.
Last Step:
Turn off Wi-Fi Calling on your phone if you have it
on. You should see full bars signal on your handset. Enjoy
more dependable voice calls and more reliable high speed
data connection.