TA CMI User Manual - page 17
TA-CMI
31
TA-CMI
30
Instrument Setup and Information
Instrument Setup and Information
Instrument Setup
In the Instrument Setup menu you can set the parameters described in this
section.
Language
When you change language, the default measurement units will automatically be changed to
the most commonly used in the corresponding country. You can adapt the unit settings accord-
ing to your requirements in the Units menu (see below).
Backlight
The backlight will stay on after any key is pressed. Here you can set the duration it stays on
from 30 seconds to 5 minutes.
Contrast
Setting the LCD contrast for optimal reading
Sleep
TA-CMI will go into sleep mode after a period when the keys are not pressed. Here you can set
the period from 1 to 10 minutes. If Sleep delay is set to “OFF” the instrument will not go into
sleep mode when it is not used.
Key beep
Turning on and off the key beep sound
Radio
Turning on and off radio communication between the instrument and sensor units. Selecting
radio communication channel. If the radio channel is set to “Sleeping”, the radio communica-
tion is off until the sensor unit has been connected to the instrument unit via the cable.
Instrument Setup and Information
Information
In the Information menu you can access information about:
• The instrument unit program version
• The instrument unit battery status (volt, current, temperature, capacity,
charge)
• The sensor unit program version
• The sensor unit battery status (volt, current, temperature, capacity,
charge)
You access information about the different areas
by pressing the down or up key repeatedly, then
pressing Enter.
Units
Setting the measurement units for temperature, differential pressure and flow
Always set the radio channel to “OFF” when there is risk that TA-CMI disturbs
other vital electronic devices, i.e. near medical equipment and implanted cardiac
pacemakers, in health care facilities, aircrafts, blasting areas, areas with poten-
tially explosive atmosperes and other areas posted “turn off two-way radio”!
2.
You then set the current parameter by pressing
the down or up key repeatedly, then pressing
Enter.
3.
Leave the Instrument Setup menu and save
your settings by pressing Done.
1.
You select any of the parameters by pressing
the down or up key repeatedly, then pressing
Enter.
Shown below is an example of how you set any of the parameters described on previous page.
!