TAC 461.110M Manual - page 2
ForceCheck Wireless Display Manual
461.110M
14-0707 / Page 2 of 2
Uncontrolled Document
ForceCheck Wired and Wireless Display Manual
461.110M
109 North Main Street | Rockford, IL 61101 USA
Tel. 815 962-5600 | Fax 815 962-4600
www.tac.us | info@tac.us
The display has several options that can be selected using the Function and Mode buttons. The chart below
outlines the display’s menu structure.
0 N
Display:
Force
Units:
Newton
AutoOff:
Off
Lang.:
English
Mode
Mode
Mode
Mode
Mode
SN 12345
Display:
F/Peak
Units:
kg-force
AutoOff:
On
Lang.:
Deutsch
Mode
Mode
Mode
Mode
Last Cal
01-2009
Display:
F/RPM
Units:
lb-force
Lang.:
Español
Mode
Cal Due
01-2010
Function
Function
Function
Function
Language:
English, Deutsch, Español.
AutoOff:
With AutoOff “On”, the display will
automatically turn itself off after approximately 1
minute of inactivity.
During normal operation, information on the
connected sensor can be obtained by pressing the
Mode button. The following are shown sequentially:
SN:
Sensor serial number.
Last Cal:
Date sensor was last calibrated.
Cal Due:
Date sensor is due for calibration.
Display Key
Force:
Display measured force only
F/Peak:
Display current measured force over peak
force.
F/RPM:
Display current measured force over
RPM (only active for wireless sensors with RPM
measurement capability).
Units:
Newton: Newtons (1 kN = 1,000 N)
kg-force: kilogram-force (equivalent to kilopond)
lb-force: pound-force