Contents qty description 2 front leg assemblies (with stainless steel pull pin) 2 rear leg assemblies (with stainless steel push pin) 1 port ring side 1 starboard ring side 3 ring cross braces 58-1/4" 2 ring joiners 45-1/2" 6 tubingjoinerfittings 4 1-1/4" x 1/2” joiner pins 4 tubing clamps 1 porttop...
1) install the port mounts. Remember the legs rake toward the stern, the mounts are machined to allow the leg to fit in at the correct angle. It is imperative that the legs are vertical left to right (figure 3). Tip: to achieve a tighter fit to the console, the console mounts can be cut down using a...
Assembling the ring 1) pass the 2" screws through the larger diameter holes in the ring sides. There are 3 holes in each side ring. 2) placethetubejoinerfittingsoverthethreadsofthe2"screwsandgentlythreadthemin. Do not tighten yet! 3) pushtheringcrossbracesoverthejoinertubefittingsononeoftheringsides...