Tactic AnyLink SLT Instruction Manual

Manual is about: 2.4GHz Radio Adapter

Summary of AnyLink SLT

  • Page 1

    The anylink slt 2.4ghz radio adapter allows nearly any r/c transmitter (tx) to bind with tactic’s ultra-small, lightweight, and inexpensive 2.4ghz receivers (rx). Futaba ® and hitec ® brand transmitters must have a trainer jack. Jr ® and spektrum ® transmitters must have a charge jack and trainer/d....

  • Page 2: Mounting Anylink

    2 mounting anylink mount anylink high on the rear of the tx, and extend its antenna to point upwards from the top of the tx as much as possible. Rotate the antenna as shown above. Two strips of hard locking fasteners are included for attaching anylink to the rear of the host tx. Input power and tran...

  • Page 3: Warning:

    3 warning: failure to insert the cable connector properly can damage the anylink and the transmitter! An optional cable is required to connect hitec’s aurora tx to anylink (see page 9). Remove the antenna and module from the aurora tx.Once connected to anylink, attach the cable’s second connector to...

  • Page 4: Anylink Operation

    4 anylink operation important! Remove the propeller from the airplane prior to operating anylink with the radio system. Failure to do so could result in personal injury if the motor unexpectedly turns during setup. 1. Remove the rf module or crystal from the host tx if possible. Leave the tx’s own a...

  • Page 5: Aileron

    5 6. Confirm that anylink’s led is now on. Apply power to the rx and servos. Move the tx sticks to determine if all controls in the model are mapped correctly as shown in this table. If mapped correctly, skip to the tactic receiver section on page 6. If some channels are not mapped properly, go to t...

  • Page 6: Note:

    6 7. Release the tx rudder stick. If anylink was previously in futaba/ hitec mode, it should now have sounded two tones ● ● to indicate it’s now in jr/spektrum mode. If anylink was previously in jr/ spektrum mode, it should now have sounded one tone ● to indicate it’s now in futaba/hitec mode. Note:...

  • Page 7: Failsafe Function:

    7 failsafe function: many of tactic’s fl ight receivers include a failsafe function which can engage if the radio signal from anylink somehow becomes interrupted. Refer to the instructions included with your tactic rx to determine if it includes the failsafe function. If radio signal is broken, the ...

  • Page 8: System Check and Operation

    8 system check and operation check the general operation of the system and all flight equipment before attempting a flight. Warning! During all pre-flight preparations with the aircraft on the ground, make sure the throttle stick remains at the minimum position and do not stand the tx upright on the...

  • Page 9: Inactivity Alarm:

    9 5. Observe the model’s surfaces to ensure they move to the previously set failsafe positions. 6. If failsafe operation is correct, re-connect power to the system as explained earlier and prepare for fl ight. If the failsafe function does not operate correctly, re-check the tactic receiver and syst...

  • Page 10: Specifications

    10 specifications compatible tx’s: futaba, hitec, jr, and spektrum transmitters, 9 channels maximum compatible rx’s: tactic brand receivers frequencies: 2.403 – 2.480ghz modulation: fhss spread spektrum power indicator: led with audible tones inactivity alarm: audible tones after 4 minutes of tx sti...

  • Page 11: Troubleshooting

    11 troubleshooting range is short: interference – check rx installation and servo connections . Low tx or rx battery – replace the batteries or recharge as needed . Any link case and/or antenna not oriented properly – rotate anylink on tx, or re-direct position of the antenna. Rx location – relocate...

  • Page 12: Fcc Statement

    12 fcc statement this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions. (1) this device may not cause harmful interference. (2) this device must accept any interference received, including interference that may cause undesired operation. Fcc rf radi...

  • Page 13: Declaration of Conformity:

    13 declaration of conformity: product: tactic anylink slt 2.4ghz radio adapter item number: tacj2000 equipment class: 1 tactic anylink slt 2.4ghz radio adapter: the objects of the declaration described here are in conformity with the requirements of the specifi cations listed below, following the pr...

  • Page 14: Hobby Services

    14 1-year limited warranty – *u.S.A. And canada only tactic warrants this product to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase. During that period, tactic will, at its option, repair or replace without service charge any product deemed d...

  • Page 15: Anylink Transmitter

    15 anylink transmitter compatibility chart* 4yf, 4ybf, 6j, 6ex, 7c, 9c, 8fg, 10c, 12fg futaba ® hitec ® j.R. ® spektrum ® 10x, quattro xp6102, xf421, xp783, x9503, x9303, xp8103, x388s dx6, dx6i, dx7 tower hobbies ® 6xm 4fm, 6fm 4vf, 5u, 6da, 6h, 6a, 6yg, 6yf, 7nfk, 8u, 9z prism 7 & 7x; focus 4 & 6;...

  • Page 16

    ™ © 2011 hobbico ® , inc. Made in china tacj2000mnl tacticrc.Com tx-ready.Com tacj2000 anylink mnl.Indd 16 tacj2000 anylink mnl.Indd 16 10/26/2011 1:04:29 pm 10/26/2011 1:04:29 pm.