Tactic TTX410 Instruction Manual - Receiver (Rx)

8

RECEIVER (Rx)

Mount the Rx as specified in the model’s instructions. Wrapping the Rx with foam rubber can help to prevent 

damage resulting from vibration but could prevent adequate airflow from passing over the Rx. See the 

SERVOS AND ACCESSORIES section for other Tactic receivers to work with the TTX410.

SERVOS

Center all trims on the Tx. Install the servos in the 

model and connect linkages as shown in the model’s 

instructions. Do NOT over-tighten the mounting screws, 

as the servos should be able to move slightly to 

compensate for engine vibration. Make sure the 

pushrods are not too loose or bind in any way, and use 

a servo arm which allows for full range of motion for 

the servo. This can be tested by moving the Tx sticks to maximum positions several times while observing the 

movement of the control services. Adjust binding servos/linkages to prevent excessive draining of the battery. 

Move the Tx trims to finely adjust the servo’s center point as needed for the application.

Connect the servos to the Rx as shown. Route the wires to not interfere with moving parts.

See the SERVOS AND ACCESSORIES section on page 12 for a full list of optional servos.

RECEIVER and FLIGHT EQUIPMENT INSTALLATION 

(if applicable)

CH6 Auxiliary (inactive for TTX410)

CH5 Auxiliary (inactive for TTX410)

CH4 Rudder

CH3 Throttle (electronic speed control or servo)

CH2 Elevator

CH1 Aileron

BAT Battery

LED

Link Button

Rubber Grommet

Brass Eyelet

Servo

Servo

Servo

Screw

Servo Tray

Rudder

Servo

(Ch4)

Receiver

Throttle

Servo

or ESC

(Ch3)

Elevator

Servo

(Ch2)

Aileron

Servo

(Ch1)

Switch Harness

To Rx Battery

To Charger

6-CHANNEL RECEIVER

LINK