Tactical Technologies TPS24-6AC Installation Manual - N645
N645
DANGER
HIGH VOLTAGE
C
AUTION
Dangerous Voltages Inside !
No user serviceable parts inside
Do not remove covers
Equipment must be installed & serviced
by suitably qualified service personnel
in a restricted access area.
General
These power supplies are designed for
indoor use only.
TPS24-6AC models are available with 1, 2, 4 or 10 individually fused outputs - each provided with a LED indicator to
display circuit status, a handy feature for quick troubleshooting of cabling or camera faults. The TPS24-6AC Series
is particularly handy for installations requiring relatively high current output for a small number of cameras eg Pan
Tilt Zoom or IR Illuminators.
The Tactical 24AC Series includes models ranging from 2A to 20A output, with 1, 2, 4, 10 or 20 individual fused
outputs (model dependant). Check www.tac-tec.com.au or your Tactical Distributor.
TPS24-6AC Model Variants:
TPS24-6AC
24Vac 6A CCTV Power Supply in small enclosure ( 202L x 136W x 82H mm )
TPS24-6AC-BD2
24Vac 6A CCTV Power Supply with 2 x 2A Fused Outputs ( 310W x 240H x 60D mm )
TPS24-6AC-BD4
24Vac 6A CCTV Power Supply with 4 x 1A Fused Outputs ( 310W x 240H x 60D mm )
TPS24-6AC-BD10
24Vac 6A CCTV Power Supply with 10 x 400mA Fused Outputs ( 310W x 240H x 60D mm )
Connection
TPS24-6AC has a single fused output with a single set of screw terminals.
TPS24-6AC-BDXX models are fitted with a Tactical Technologies PDM (2, 4 or10 way) Power Distribution Module.
In order to provide maximum short circuit protection, it is recommended that the installer assess the current draw
of each device connected to the PDM and fit a fuse of appropriate value to suit.
Ensure that total device current draw does not exceed the rated output of the power supply, remembering to
allow an adequate power margin for equipment cold start.
For your convenience, an LED is fitted adjacent to each fuse. The LED is lit when the fuse is intact and extinguished
when the fuse has failed.
Note that TPS24-6AC-BDXX models have a 240V primary side fuse fitted in an integrated fuse holder within the IEC
type Power Socket Connector fitted on the lower edge of the cabinet - TPS24-6AC has an inbuilt (non-serviceable)
fuse inbuilt into the transformer.
TPS24-6AC Series_Rev C.pdf
www.tac-tech.com.au